Agilent Technologies 3458A Repair Manual page 60

60 Chapter 3 Disassembly/Assembly Procedures and Parts List
the chassis, then push the left side of the Front Panel assembly over the
chassis standoffs until it locks in place.
11. Install the top trim into the channel on top of the Front Panel assembly.
Lock it in place (see Figure 22).
12. Install the current terminal/fuse assembly into the binding post. Push
the assembly in and turn counterclockwise until it locks in place.
13. Refer to Figure 22. Guide the Front/Rear Terminals switch pushrod
through the rear of the front panel's access hole. Then align the
pushrod with the Front/Rear Terminals switch shaft and push it all the
way onto the shaft.
14. Set the 3458A on your workbench with the bottom facing you.
15. Refer to Figure 21. Do the following:
a. Guide the Guard switch pushrod through the rear of the front
panel's access hole. Then align the pushrod with the Guard switch
shaft and push it all the way onto the shaft.
b. Guide the power switch pushrod through the rear of the transformer
shield's access hole. Then guide the pushrod through the rear of the
front panel's access hole. Align the pushrod with the ac power
switch shaft and push it into the onto the shaft.
c. Locate the grey 26-pin cable connected to the Display Logic
assembly. Line up the cable plug with the socket on the Outguard
Power Supply assembly connector. Then plug the cable all the way
in.