Advertisement
Quick Links
WELDING INVERTER FOR PIN BRAZING
USING INVERTEC 400SX with the BAC Easybond Generator Gun.
1./
Switch power on at the rear of the unit
A. Power Switch: Turns input power On/Off to the machine
B. Input Cable: Connect it to the mains.
2./
Set the welding mode to stick user defined parameters
3./
Set Current to 240 Ampere (245 max) using the output current control knob
Ensure that you read the Operator's Manual and fully
familiarize yourself with all the safety and operational
requirements prior to using this equipment
Advertisement
Summary of Contents for BAC 400SX
- Page 1 WELDING INVERTER FOR PIN BRAZING USING INVERTEC 400SX with the BAC Easybond Generator Gun. Ensure that you read the Operator’s Manual and fully familiarize yourself with all the safety and operational requirements prior to using this equipment Switch power on at the rear of the unit A.
- Page 2 Start knob. Do not set output Current higher than 245 amperes. Once the Brazing Pins are firing to the required standard make a note of the settings for future reference. BAC Corrosion Control Ltd Stafford Park 11, Telford, Shropshire, TF3 3AY Tel: +44 (0) 1952 290321 Fax: +44 (0) 1952 290325 Email: sales@bacgroup.com...