Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Huddly L1
Summary of Contents for Huddly L1
- Page 1 Huddly L1 Product and Compliance Information Valid for H3AC HD-PGDE-0107-A1...
-
Page 2: Table Of Contents
Contents Safety and Caution Information Temperature Modify User Instructions Installation Power Factory reset Streaming Regulatory Compliance Information Canada Industry Canada statement United States FCC compliance statement Australia and New Zealand European Union EU Single Point of Contact European Union EMC Directive conformance statement Support EULA... -
Page 3: Safety And Caution Information
Safety and Caution Information Temperature This device is intended for use in ambient temperatures between 0 °C and 35 °C (32 °F and 95 °F). Avoid using or storing next to heat sources, in direct sunlight, or outside the intended temperature ranges. Modify Modification to thermal solution, device components or enclosure shall violate regulatory compliance requirements... -
Page 4: User Instructions
User Instructions The L1 camera is made for easy installation, using only a single RJ45 Ethernet cable for both power and communications with a host computer. Installation Use the ¼” tripod mount found on the bottom face of the camera to attach a bracket to the L1. Using the bracket, mount the L1 at a maximum height of 2m. -
Page 5: Factory Reset
Streaming Protocol (RTSP) and Open Network Video Interface Forum (ONVIF). Factory reset To reset the L1 to factory default, use the following procedure: 1. Disconnect the Ethernet cable from the camera 2. Use a thin object to press the reset button... -
Page 6: Regulatory Compliance Information
Regulatory Compliance Information This product is cNus marked in accordance with the requirements of the applicable standards for Canada and the United States. Canada Industry Canada statement This Class A digital apparatus complies with CAN ICES-3 (A)/NMB-3(A). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. -
Page 7: Australia And New Zealand
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio... -
Page 8: European Union
European Union EU Single Point of Contact Huddly AS, Attn: Compliance Karenslyst allé 51 0279 Oslo, Norway European Union EMC Directive conformance statement This product has been tested and found to comply with the limits for Class A equipment according to European Standards harmonised in the Directives in compliance. -
Page 9: Support
By using this product, you agree that your use of this product is subject to our End User Licence Agreement terms available at: www.huddly.com/eula Privacy policy Our privacy policy is available at: www.huddly.com/privacy-policy You can find further compliance information at: www.huddly.com/L1/compliance...
Need help?
Do you have a question about the L1 and is the answer not in the manual?
Questions and answers