Advertisement
Assembly / Installation
INTRODUCTION
Pump suction filters maintain a natural balance, clear
water, and healthy fish and plants in your pond.
Pond pollutants can accumulate at the bottom of the
pond. The pollutants dissolve into the pond water, pro-
ducing harmful toxic by-products. These by-products will
affect fish health and cause cloudy water. The pump suc-
tion filter has been specifically designed to remove harm-
ful pollutants by converting them into harmless gases
which will evaporate into the atmosphere. No chemical
additives are required.
How it works
As pond water enters the filter, it flows in and around the
®
patented Flocor
filter media. This filter media is
designed to offer a large surface area for the colonization
of "friendly" bacteria that will consume harmful toxins in
the water. Water clarity is increased because the filter
removes the nutrients that algae and blanketweed thrive
on.
ASSEMBLY
The pump suction filter is designed to connect to the
intake of any Sears water garden pump. Remove the
existing inlet filter housing and sponge that was original-
ly supplied with your pump before installing the extra
capacity inlet filter. This is accomplished by gently twist-
ing the existing inlet filter housing clockwise and pulling
outward at the same time.
The pump suction filter is connected to the inlet of the
pump with the hose supplied. An adapter is also sup-
plied for connection to some models of pumps (Table 1).
On smaller pumps the adapter fits over the outside of the
pump inlet and on larger pumps the adapter fits inside of
the pump inlet.
For one year from the date of purchase, Sears will replace this filter, free of charge, if defective in material
or workmanship.
This warranty does not cover repairs or replacement parts necessary because of abuse or negligence
including failure to install, adjust and operate this filter according to the instructions in the owner's
manual.
SEARS WILL NOT BE LIABLE FOR LOSS OR DAMAGE TO PROPERTY OR ANY INCIDENTAL OR CON-
SEQUENTIAL LOSS OR EXPENSE FROM PROPERTY DAMAGE DUE DIRECTLY OR INDIRECTLY
FROM THE USE OF THIS PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you.
WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS SERVICE CEN-
TER/DEPARTMENT IN THE UNITED STATES. This warranty applies only while the product is in use in the
United States.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to
state.
FULL ONE YEAR WARRANTY
LIMITATION OF WARRANTY
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
INSTALLATION
The cover illustration shows a typical water garden and
fountain installation with the use of the pump suction fil-
ter. The filter can be placed at any location in the pond
that the hose length will reach, either above or below the
pump. The filter must be submerged at all times when
pump is running, or damage to the pump will result.
TABLE 1
Model
390.131800, 390.132600
390.134000, 390.136200
390.137500
390.139600, 390.131130
390.131340
390.131560, 390.132100
Adapter slips over pump suction
for fountain pump models:
FPWG-180FK
390.131800
FPWG-260FK
390.132600
FPWG-400FK
390.134000
FPWG-620FK
390.136200
Adapter slips inside pump suction
for fountain pump models:
Figure 1
2
Adapter Required
Yes (outside)
No
Yes (inside)
681 0495
390.131340
FPWG-1340FK
FPWG-1560FK
390.131560
FPWG-2100FK
390.132100
Advertisement
