NexxTech 8003100 Operating Instructions

8003100
OPERATING INSTRUCTIONS
FEATURES
1. Bright, blue backlight
2. Red flashing alarm light
3. Large Snooze/Light button
4. Protective cover for travelling
5. Easy-to set time and alarm controls
6. Requires two (2) "AAA" batteries
(not included)
BATTERY
This model requires two "AAA" batteries (not included).
To install the batteries, remove the battery door located on the back of the
clock. Insert two "AAA" batteries following the polarity symbols (+/-) marked
on the inside of the battery compartment. Replace the battery door.
If the clock does not activate after inserting the batteries, check to make
sure the battery is properly installed and/or check to make sure the battery
is fresh.
If the clock does not operate, or steadily loses time, or if the alarm sounds
weak, the batteries are low and should be replaced.
WARNING: Keep out of reach of children. If swallowed call your
doctor immediately. DO NOT open battery, dispose of in fire, charge,
install backwards or mix with used or other battery types.
May explode or leak and cause personal injury.
SETTING THE TIME
Move the slide switch (B) to the "T. SET" position.
Press the Hour button (C) continuously until the
correct hour is displayed.
Note: "PM" will display in the upper left corner of
the display for PM hours. Next, press the Minute
button (D) continuously until the correct minutes
are displayed.
SETTING THE ALARM TIME
Move the slide switch (B) to the "AL. SET" position. Set the desired alarm
time in the same way used to set the time. Press the Hour button (C)
continuously until the correct hour is displayed. If the Alarm Time desired is
a PM time, "PM" will be displayed in the upper left corner. Next, press the
Minute button (D) continuously until the correct minutes are displayed.