Water Hose Installation; Oil Warning System - Yamaha YP20G Owner's Manual

CE00162

WATER HOSE INSTALLATION

1. Install the hose joints on the pump.
cC
When installing the joint to the pump, be sure the
gasket is in place.
2. Connect the hoses on the joints with clamp.
3. Connect the strainer on the inlet hose end.
cC
9 Be sure the hoses are installed securely or air
leak will occur and water will not be drawn up.
9 Be sure the strainer is installed or pump dam-
age will occur.
cC
Install the strainer
A) 50 mm (2 in) suction port diameter for YP20G
or
B) 80 mm (3 in) suction port diameter for YP30G
both with filtering perforations 8 mm (0.31 in) or
less in diameter.
AE00111

OIL WARNING SYSTEM

When the oil level falls below the lower level, the
engine stops automatically. Unless you refill with oil,
the engine will not start again.
NOTE:
If the engine stalls or does not start, turn the engine
switch to "ON" position and then pull the recoil starter.
If the oil warning light flickers for a few seconds, the
engine oil is insufficient. Add oil and restart.
– 7 –