Download Print this page

Advertisement

Quick Links

P07
2x20V Snow Thrower
EN
P15
WG471E WG471E.9

Advertisement

loading
Need help?

Need help?

Do you have a question about the WG471E and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Worx WG471E

  • Page 1 2x20V Snow Thrower WG471E WG471E.9...
  • Page 6 100%...
  • Page 8 PRODUCT SAFETY power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol GENERAL POWER TOOL or medication. A moment of inattention while SAFETY WARNINGS operating power tools may result in serious personal injury.
  • Page 9 Check for misalignment or binding of moving b) Never service damaged battery packs. parts, breakage of parts and any other condition Service of battery packs should only be that may affect the power tool’s operation. If performed by the manufacturer or authorized damaged, have the power tool repaired before service providers.
  • Page 10: Safety Warnings For Battery Pack

    Wait 10 seconds to be sure the impeller blades n) Recharge only with the charger specified have stopped rotating. by WORX.Do not use any charger other Always use a clean-out tool, not your hands. than that specifically provided for use with the equipment.
  • Page 11 SYMBOLS Batteries may enter water cycle if disposed improperly, which can be hazardous for ecosystem. Do not dispose of waste batteries as unsorted municipal waste. Warning Remove battery from the snow thrower before carrying out Read the operator’s manual. any adjustment, servicing or maintenance.
  • Page 12: Component List

    Battery pack (WA3553) Charger (WA3883) TECHNICAL DATA Cable clip Hex key Type WG471E WG471E.9 (4 - designation of machinery, representative of Battery-operated We recommend that you purchase your accessories snow thrower) from the same store that sold you the tool. Refer to the accessory packaging for further details.
  • Page 13: Assembly And Operation

    OPERATION INSTRUCTIONS Adjusting throw direction and throw height NOTE: Read instruction handbook before NOTE: The discharge chute operation this machine. can be adjusted 180 degrees by rotating the chute rotation INTENDED USE: handle. This tool is intended for snow throwing. It is only for WARNING: Never direct outdoor usage.
  • Page 14: Maintenance

    Two, three or four The two batteries have OPERATION green lights are a remaining charge. The Starting & stopping See Fig. I illuminated. more lights are illumi- Battery power indicator on the nated, the more battery machine capacity. See details in BATTERY STATUS part Only one green At least one battery is...
  • Page 15: Environmental Protection

    3. Inspect the snow thrower carefully for worn, loose, or damaged parts. Check connections and screws and tighten if necessary. For repairing or replacing parts, contact your WORX dealer. 4. Store the unit, along with the removed battery TROUBLE SHOOTING The following table gives checks and actions that you can perform if your machine does not operate correctly.
  • Page 20 Li-I on Li-I on...
  • Page 28 Copyright © 2019, Positec. All Rights Reserved.

This manual is also suitable for:

Wg471e.9