Advertisement
Mounting options
In both mounting options the one piece keyer board or separate connector board are designed to
mount to the 1/16" thick wall of your chassis, and is held in place by the threaded ring supplied with the
3.5mm jack. All that is needed is to drill two holes, as described below and mount the keyer board or
connector board directly with the 3.5mm jack that is soldered to the pcb. The pushbutton is slightly
higher than the 3.5mm jack.
As viewed from the outside
General operation notes:
The paddle input connections to the keyer are set up for the tip being "dit", the sleeve to be
"dah" on a 3.5mm stereo plug, and the barrel is ground.
Connect the "Function Tone" pad to your audio output device, so you can hear the function prompts.
Page 6 of 9
skc_assy_041722.pdf
Advertisement
