Advertisement
1. Disconnect the negative battery cable!
2. Loosen clamp at intake manifold leaving clamp on plastic tube.
3. Slide the plastic tube back and insert spacer into tube.
4. Reinstall the plastic tube making sure the spacer is engaged in manifold while locating and tighten-
ing the hose clamp.
5. When installing the spacer in the intake manifold, face the spacer using the illustration below.
6. Before tightening the intake manifold clamp, be sure that the spacer has engaged both the intake
manifold and plastic intake tube. **The outside diameters of the spacer will fit the inside diame-
ters of the intake manifold and the plastic intake tube.
7.
Reconnect negative battery cable. Enjoy!
INTAKE MANIFOLD
The sound of power...The "whistle" means its working!
Contact your nearest AIRAID dealer for an AIRAID Intake
Airaid. 1455 Citrus St. Riverside, CA 92507 (800) 498-6951
SPACER
System for your car, truck or SUV.
PLASTIC TUBE CLAMP ASSEMBLY
PLASTIC INTAKE TUBE
AiraidInfo@airaid.com
2
AIR-I40602B
Rev. 10.27.20
www.airaid.com
Advertisement
