Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for E-Z Anchor Puller EZ-0411
- Page 2 The purpose of this manual is to clarify the controls on the wireless remote key fob and address common troubleshooting questions. For additional support, contact E-Z Anchor Puller Mfg. Co. at the phone number listed in the footer or email support@ezanchorpuller.com. The long range wireless remote control comes with two (2) key fobs (batteries included) and the Wireless Receiver Unit that will be connected to your anchor winch solenoid.
- Page 3 Email Questions to support@ezanchorpuller.com Part 3 - Upkeep and Use Instructions for your Wireless Remote Control: After following the diagram above and successfully connecting the wireless receiver to your drum anchor winch solenoid, slide down the protective cover on your wireless remote key fob and hold the “On/Off” button for three seconds to begin operation.
- Page 4 Email Questions to support@ezanchorpuller.com COMMON TROUBLESHOOTING QUESTIONS: Issue Possible Cause(s) Solution(s) *numbers correlate to each other Wiring Switch the green and yellow solenoid coils on the △ Up ( ) deploys anchor; Down (▽) retrieves the Wireless Receiver Unit attached to the solenoid Remote does not power the anchor winch;...
Need help?
Do you have a question about the EZ-0411 and is the answer not in the manual?
Questions and answers