Rennsteig R624 570 3 1 RT Quick Manual

SOLAR SYSTEM TOOL FOR MC4
VISUAL AID
THE SOLAR SYSTEM TOOL IS DESIGNED FOR CRIMPING MC4 SOLAR MALE AND FEMALE TERMINALS 14/12/10 GAUGE
(SIMILAR TO 2.5/4/6 MM2) SOLAR WIRES.
R624 570 3 1 RT: TOOL W/ LOCATOR FOR MC4 MALE & FEMALE 14/12/10 GAUGE
R624 570 3 RT: TOOL W/O LOCATOR FOR MC4 MALE & FEMALE 14/12/10 GAUGE
CAUTION!
This tool may be used only for the intended applicati on and in strict compliance with all applicable safety rules, regulati ons and practi -
ces. It must be properly maintained, undamaged and in good working order. Unauthorized modifi cati on is prohibited and voids the
manufacturer's warranty. TERMINALS MAY HAVE SHARP EDGES. USE FINGER PROTECTION TO AVOID CUTS. DO NOT PLACE FINGERS IN
TOOL AREAS, WHICH MAY PINCH DURING CRIMP CYCLE. USE SAFETY GLASSES TO AVOID EYE INJURY.
Step 1
2 2
3 3
1. Tool 1. Tool 2. Die Set 2. Die Set
Step 3
Version without Wire Stop Version without
Hold tool so that the terminal can drop into the Locator Hold tool so that the terminal can drop into the Locator
round hole. Make sure terminal is fully seated in the round hole. Make sure terminal is fully seated in the
Locator. Locator.
Step 5
Version with Version with Wire Stop
The Locator off ers a wire stop which also holds the
terminals in the right positi on. Make sure the wire stop
is open before you insert the terminal.
Rennsteig Tools, Inc. | 301 Route 17 North | Rutherford, NJ 07070
Phone: 330-315-3044 | Fax: 330-319-8135 | Mail: info@rennsteig.us | Web: www.rennsteig.us
1 1
3. Locator 3. Locator
without Wire Stop
with Wire Stop
Step 2
Compress handles unti l ratchet releases to open Compress handles unti l ratchet releases to open
handles. Select cable size as shown on top of crimp handles. Select cable size as shown on top of crimp
plate. plate.
Step 4
Version without Wire Stop
If necessary use your fi ngers for assistance to prevent If necessary use your fi ngers for assistance to prevent
the teminal from twisti ng. the teminal from twisti ng.
Step 6
Version with Wire Stop
Hold tool so that the terminal can drop into the
Locator. Make sure the terminal is fully seated in the
Locator and wire stop is closed to orient the terminal.
Instructi on video