Advertisement
Powering On and Opening the Lid
1. Turn the pill dispenser upside down.
2. Slide the battery door latch to unlock and remove the battery door.
3. Insert the included 4 AA batteries making sure that they are placed in
the correct direction.
4. e-pill Voice is now on.
5. Replace the battery door and slide the door latch to its lock position.
6. Keep the dispenser upside down and unlock its large round cover. To
unlock, insert the key into the silver lock. Turn the key a ¼ of a turn.
WARNING: The dispenser's lock should only be turned a ¼ of a turn.
Overturning the key can cause the lock to break.
7. Turn the dispenser right side up.
8. On the front of the lid, push the PRESS tab down until you hear a
click. The door is now unlatched. Lift up to open.
Clock - Setting the Clock
1. Press and hold button A for a few seconds until ":" stops blinking
(located between the hours and minutes), then release.
2. Tap button B to advance the hours (note AM/PM).
3. Tap button C to advance the minutes.
4. Tap button A to save, ":" will now blink.
5. e-pill Voice will confirm with "Pill Dispenser Settings Updated."
6. Optional: Set the clock to use the 24-hour time format. e-pill Voice is set
to use the 12-hour time format (AM/PM) by default. To switch to 24-
hour format:
a. With the current time displayed, tap button C.
b. Tap button C again to switch between 12-hour (AM/PM) and 24-
hour time formats.
c. Tap button A to save.
d. e-pill Voice will confirm with "Pill Dispenser Settings Updated."
Alarms - Setting Alarms
Alarms must be set in order starting with the earliest.
1. Tap button A. "1" will appear next to the alarm clock symbol.
2. Tap button B to set the hour (note AM/PM) & button C to set the
minutes.
3. Tap button A to save and to advance to the next alarm.
4. Repeat steps 1-3 until all your alarms are set.
SETUP – STEP 1
4
Advertisement
