Table of Contents
Advertisement
Available languages
Available languages
ChARGING
1)
Charge the shaver where the temperature is above 0 °C and below 40 °C.
2)
Rated input voltage of the shaver is DC 5.0 V. Avoid charging the shaver too long time since
it will shorten the product life.
3)
Connect the power cord of the adaptor to the shaver, and plug the adaptor to an AC outlet.
Or connect the adaptor to the charger base, plug the adaptor to an AC outlet and insert the
shaver in the charger base.
4)
Take out the power adaptor, insert the plug at its tail end into the shaver's tail interface, and
insert the other end into the power outlet. At this time, the background lamp will turn on, and
then the shaver starts to charge.
5)
Pull out the power adapter after it has been fully charged, and then the charging process is
finished.
6)
The red charge status lamp will glow when the shaver is being recharging, you can fully
charge the shaver in 8 hours.
Optimize the working life of the battery
•
After the Clipper has been charged for the first time, do not recharge the Clipper between
trimming sessions. Continue using it until the battery is completely empty.
•
Do not charge for more than 12 hours.
•
Do not keep cord permanently plugged in.
•
Discharge/ run down the battery completely twice a year by letting the motor run until it stops.
•
If the Clipper hasn't been used for a long period of time, it must be recharged for a full 10
hours.
OPERATION
Coat the soap foam over skin, take out the protective cover and turn on the switch. In order to
reach optimal result, trim the hairs counter their growth direction. Flatly press the head of the
hair trimmer against the skin to make both two pieces of trimming scissors and the external
blade screen simultaneously work. Before use, please trim the long hairs with the jump-type
trimming scissors.
Wet shaver
The shaver is suitable for use in a bath or shower.
But never shaver immerse in water!
ENG - 20
Advertisement
Table of Contents
