Prior To First Use - HOMCOM 800-094V70 Assembly Instruction Manual

PRIOR TO FIRST USE

Before using the appliance for the first time, you should proceed as follows: carefully
unpack the hot air fryer and remove all packaging material and any promotional stickers.
Keep the packaging (plastic bags and cardboard) out of the reach of children. After
unpacking the appliance, check it for external damage that may have occurred during
transport. Place the hot air fryer on a sturdy, flat and heat-resistant surface.
The buttons used for opera ting the hot air fryer; are touch controls and an easy control
rotary knob. Carefully touch the touch controls with a finger to activate. Each time the touch
control is touched and the rotary knob is turned, you can hear a sound signal.
STANDBY
As soon as you insert the plug in the socket, the hot air fryer is in the standby position. The
standby key lights up.
In the following situations, the hot air fryer automatically switches to the standby position:
• when you insert the plug in the socket
• when the set time has elapsed
• when you press the standby key
SWITCHING ON AND OFF
Switch on the hot air fryer with the standby key
• The hot air fryer only functions if the basket has been placed in the pan correctly.
• As soon as the set time has elapsed, the hot air fryer automatically switches to the
standby position: The fan does not continue to run in order to allow the hot air fryer to
cool down. After approximately 20 seconds, 5 beeps will sound and the thermostat
indicator is switched off.
• Attention: during cooling it is not possible to operate the display.
PRIOR TO FIRST USE
Check that the voltage corresponds with what is stated on the information plate and insert
the plug in a grounded socket. The heating element is provided with a protective layer
that must be removed prior to first use. This is done by setting the hot air fryer to the
maximum position for approximately 10 minutes without any food in the appliance. A little
smoke may be generated due to the protective layer being burnt off the heating
element. Therefore ensure sufficient ventilation in the room. After removing the protective
layer you can switch off the hot air fryer.
Remove the plug from the socket. Allow the hot air fryer to cool down properly and clean
loose comp orients prior to actually using the hot air fryer. Clean the basket and pan with
warm water; a mild washing-up liquid and a soft sponge.
Tip: these components may also be cleaned in the dishwasher.
Clean the interior and exterior of the appliance with a damp cloth.
for 4 seconds