Installation - Zanussi ZRB36101WA User Manual

Problem
Water flows on the floor.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
Replacing the lamp
The appliance is equipped with a
longlife LED interior light.
CAUTION!
Disconnect the plug from the mains
socket.
Installation
WARNING!
Refer to Safety chapters.
www.zanussi.com
Possible cause
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
1. At the same time, with the fingers expand
2
2. Replace the lamp with one of the same
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
up and down the transparent cover and
unhook it in the direction of the arrows.
1
1
power and shape, specifically designed for
household appliances. (the maximum power
is shown on the light bulb cover).
Make sure that the light comes on.
Solution
23