Advertisement
Screw (Inside)
Hole
#4 x
/
" (1.9 cm) Screw
3
8
Shown Actual Size
ASSEMBLY
Blades
Post
3
CAUTION
This toy contains small parts
in its unassembled state.
Adult assembly is required.
Note: Tighten and loosen all screws
with a Phillips screwdriver. Do not
over-tighten screws.
• Fit the pegs on the bottom of the
helicopter through the holes in the
landing gear as shown.
• Insert the four screws through the
holes on the bottom of the landing
gear. Tighten the screws.
• Fit the blades onto the post on the
top of the helicopter.
• Insert a Phillips screwdriver into the
hole in the top side of the blades
and tighten the screw.
Advertisement
