Table of Contents
Summary of Contents for Yescom 33EPW002-3000P-02
- Page 1 High Pressure Cleaner USER MANUAL Read the instructions before using the machine. Appropriate hearing protection should be used when using the cleaner. Wear safety glasses when using the cleaner. Do not connect it to the potable water mains.
-
Page 2: General Safety Rules
GENERAL SAFETY RULES This machine has been designed for use with the cleaning agent supplied or recommended by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the machine. Do not use the machine within range of persons unless they wear protective clothing. ... -
Page 3: Additional Safety Instructions
ADDITIONAL SAFETY INSTRUCTIONS In order to safely use the cleaner, make sure that you have read all of these instructions and checked the machine before operation. Have a try before the official use. The machine, hose and plug must be checked before the operation. Defective parts ... - Page 4 Do not run the cleaner without water which will cause damage to the cleaner. Before starting the machine, fully open the water supply tap. Be careful not to bend the hose. When the machine hose or tube freeze in winter, do not use it. Before storing the water ...
-
Page 5: Technical Data
TECHNICAL DATA Rated pressure 10.0MPa Inlet (max.) 0.3MPa Max. flow 7.2l/min Rated voltage 120V Rated frequency 60Hz Rated power input 2000 W Degree of Protection IPX5 Protection class Sound power level 98 dB(A) Sound pressure level 80 ±3 dB(A) Water temperature Max. 40℃... -
Page 6: Assembly Steps
ASSEMBLY STEPS High pressure hose connection Connect the pressure hose to the machine’s outlet, ensuring it is connected firmly. See picture 1 outlet Picture 1 Gun connection Connect the gun lance(Fixed brush/turbo lance) to the gun stock. Turn the gun lance clockwise until it locked in position. -
Page 7: Operation
OPERATION Gun operation Adjust the water pressure and the shape of water column by changing the nozzle. Picture 4 High/Low Pressure Operation The nozzle controls the water pressure. Attach the high pressure nozzle. Make sure the distance between the nozzle and the workpiece is at least 11.8”/30cm. - Page 8 Switching off the appliance Turn off the water supply at the tap. Press the trigger to reduce the pressure in the appliance. Pull out the water inlet hose, and then let the machine run a few seconds to drain the water of storing in the pump.
-
Page 9: Problems And Solutions
PROBLEMS AND SOLUTIONS WARNING! DISCONNECT FROM THE ELECTRICAL POWER SUPPLY BEFORE CARRYING OUT USER MAINTENANCE. IF THE MAINS CABLE IS DAMAGED IT MUST BE REPLACED BY THE MANUFACTURER, OR ITS SERVICE AGENT OR SIMILARLY QUALIFIED PERSON TO AVOID A HAZARD. Possible problems and solutions Problem Probable cause...