Summary of Contents for scope DCSPDS
- Page 1 Programmable Dual State Voltage & Dry Contact Interface Unit DCSPDS & VSPDS Installation & Programming Manual...
- Page 2 End, including Parts 90 and 95, available from the US Gov. Printing Office, GPO Bookstore, FCC Office or www.fcc.gov/oet/info/rules/ Important Safety Information Scope products are designed to operate safely when installed and used according to general safety practices. The following requirements should be observed at all times. Do NOT subject this equipment to:...
- Page 3 All applications should be thoroughly assessed by the installer in conjunction with the customer so as to minimize risk. Scope has no control of the use and application of the frequencies issued by the FCC.
- Page 4 This product is warranted as free from defects of workmanship and materials for a period of one year from the original purchase date. During this time, if there is a defect or malfunction of this product, Scope will, with proof of purchase, repair or replace at its discretion any defective parts, free of charge.
- Page 5 Serially Programmable Dry Contact/Dual State Voltage Interface Unit Description This manual covers both the serially programmable Dry Contact interface unit and the serially programmable Dual State Voltage interface unit. These products are designed to work with systems outputting either a dry contact closure, i.e. relay output or a voltage from 5 Volts to 60 Volts DC.
- Page 6 Serially Programmable Dry Contact/Dual State Voltage Interface Unit Installation 1. Remove the cover by loosing the four screws located at the top and bottom of the unit. 2. The interface unit is mounted to the wall by four (4) mounting screws fixed through the back plate. Hold the back plate up to the mounting surface and mark the location of the mounting holes.
-
Page 7: Normal State
Serially Programmable Dry Contact/Dual State Voltage Interface Unit A. Definitions NORMAL STATE This state is set for each contact to the condition that exist when the unit is powered up. When powered up any contact that does not reflect the NORMAL STATE will be activated. - Page 8 Serially Programmable Dry Contact/Dual State Voltage Interface Unit B. Menu selections for communicating with the interface unit 1. Select DEVICE from the menu at the top of the progam. 2. Select DEVICE READ from the drop down menu if you want to read the contains of the unit. 3.
- Page 9 Serially Programmable Dry Contact/Dual State Voltage Interface Unit D. Programming interface unit with new configuration 1. Use an existing file stored on disk a. Select [FILE], [LOAD] b. Select the directory the file is located in and the file name. c.
- Page 10 Serially Programmable Dry Contact/Dual State Voltage Interface Unit E. Develop new configuration using DEFAULT SETTINGS a. Select [DEFAULT SETTINGS], b. Enter only COMMON data.. c. Select [ADD ANOTHER ZONE]. [1-10] Enter the number of Zone(s) {contacts} you will be activating NOTE: Only make connections to the contacts/zones you activate.