Yukon 62587 Owner's Manual & Safety Instructions page 3

Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram
near the end of this manual. 10mm, 14mm and 17mm sockets and/or wrenches are required for assembly.
Unwrap and separate all parts on a clear work area.
Attaching Posts to Bottom Tray
Lay the Bottom Tray (12) (the tray with four sets of four holes on the bottom) on the floor and attach the Posts
(15) to the outside corners of the tray using sixteen Bolts (2), Washers (5), Lock Washers (6), and Nuts (7).
Note: It is best to leave all nuts and bolts loose until assembly is finished, then tighten
all fasteners. This will make it easier to install and align all components.
Item 62587
Post (15)
Bolt (2) Washer (5)
Bottom Tray
(12)
For technical questions, please call 1-888-866-5797.
Nut (7)
Lock Washer
(6)
Page 3