Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Burg Corona
Summary of Contents for Burg Corona
- Page 1 Corona Operating Manual www.burg.de...
-
Page 2: Table Of Contents
Thank to its zamak components, the lock can easily withstand a force of at least 800 N. The Corona is suitable for installation in wooden and metal doors and flexibly covers different door thicknesses. -
Page 3: Technical Data
3 Transponder 125 kHz (T5577): max. 50 Corona I / Corona II: max. 40 only applies to the variant Corona I only applies to the variant Corona II after consultation / may vary for air and sea freight delivery Corona | 05-2022 Rev. -
Page 4: Scope Of Features
Holz: 16, 19, 22 mm backset: 28 mm to 56.2 mm Dornmaß: von 35,2 mm bis 56,2 mm Dornmaß: von 28 mm bis 56,2 mm min. backset: 28 mm Mindestdornmaß: 35,2 mm Mindestdornmaß: 28 mm Corona | 05-2022 Rev. 03 | English | 4... -
Page 5: Mounting Hole Dimensions
If the critical range is reached, the lock can no longer be locked or can only be opened with the master card. With the Corona II variant, locking is possible despite low battery capacity. A low battery level is signaled by the flashing of the red LED. - Page 6 Logging With the check-in function, the transponder medium receives The last 12 (Corona I) or 40 (Corona II) actions performed on the authorization to use the lock. Without this authorization, the lock are logged and can be read out and displayed using a log transponder cannot operate any lock.
-
Page 7: Led And Tone Signals
Permanent fl ashing 3 beeps The lock is locked. The transponder is not accepted (reasons for this are listed un- der ‘LED and Tone Signals for 125 kHz and Corona I‘). Flashing for 5 seconds The lock was successfully unlocked. 4 beeps... -
Page 8: Assembly Instructions
Fasten the back unit with the enclosed screws (Torx 20). It is recommended to tighten the screws diagonally one after the other. Find the assembly video here (wood): Find the assembly video here (steel): Corona | 05-2022 Rev. 03 | English | 8... -
Page 9: Configuration
Note: The function card Transponder Reset can be used to (when activated) confirm the successful process. delete all transponders. 3. Turn the knob and pull the door. only applies to the variant Corona I (incl. 125 kHz) Corona | 05-2022 Rev. 03 | English | 9... -
Page 10: Reset On Default Setting
Corona I: Remove both batteries simultaneously and 58089 Hagen (Germany) replace them within 10 seconds. Fon + 49 (0) 23 35. 63 08-0 Corona II: Remove both batteries one after the other. info @ burg.de www.burg.de 3 Insert new batteries according to the +/- symbols.