Download Print this page

SNAP STRONG SR-RACKSLIDE-300 Installation Manual

Metal rack sliding base

CABLE MANAGEMENT

1. Determine direction of rack rotation and wiring plan for this direction. Select one side of rack for signal cables,

and the opposite side for power cables. Fully extend rack and rotate 90 degrees in intended direction. Lace

cables ensuring they are fairly taut. This will help ensure that the service loop will be the correct length and not

be pinched when closing the rack.

NOTE: Wiring this way will keep the rack rotation in the direction

originally selected when cabling is complete.

Cable Management Tip:

Tie your cable bundles at least every 6" - 8". This allows cable bundles

to lay neatly together when rack is in the closed position.

19.25"

20.67"

60°

Lifetime Limited Warranty

All Strong™ products have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all

Lifetime

components found to be defective in material or workmanship under normal conditions of use. This warranty

shall notapply to products which have been abused, modified or disassembled. Products to be repaired under

this warranty must be returned to SnapAV or a designated service center with prior notification and an

assigned return authorization number (RA).

For Techincal Support : 1.866.838.5052

PG.3

38.74"

90°

120529-1000

SR-RACKSLIDE-300

Strong™ Metal Rack Sliding Base

Table of Contents

Do you have a question about the STRONG SR-RACKSLIDE-300 and is the answer not in the manual?

Page 1 CABLE MANAGEMENT 1. Determine direction of rack rotation and wiring plan for this direction. Select one side of rack for signal cables, and the opposite side for power cables. Fully extend rack and rotate 90 degrees in intended direction. Lace cables ensuring they are fairly taut.
Page 2 ATTACHING THE RACK PARTS INCLUDED: (1) Rackslide Base TOOLS NEEDED: The mounting method for each rack series is different; refer to the instructions below for the rack series being installed . (1) Rack Attachment Plate No. 2 Phillips Screwdriver (2) Blank Finish Plates ( 1 for each series rack) 1/2”...