Pearl ETHAN Quick Manual

Shower
Fixtures
Model Shown: ETHAN
P e a r l S i n k s . c o m
Introduction
Thank you for purchasing an authentic Pearl® shower set. Crafted out of the
highest quality nickel and brass, each and every xture component is tested
and carefully inspected by hand before leaving the factory.
Please read the instructions carefully to prevent malfunction and/or
damages to your plumbing and property.
Tools
The tools below may be needed to complete the installation. They are not
absolutely required, but having them will greatly assist in the installation
process. For additional information, check with your local hardware store on
the requirements for your installation.
Philips Screwdriver Flathead Screwdriver
Allen Hex Key Thread Seal Tape
Channel Locks Adjustable Wrench
Before you begin
• Read all instructions carefully before beginning installation.
• Assemble all the tools you might need.
• Flush both hot and cold water lines before proceeding with installation.
• Turn o main water supply before removing old xtures.
• Clean surfaces and work area before installing new xtures.
• Cover openings or drainage to prevent small parts from getting lost.
• Cleaning with any chemical substance will void the limited warranty.
• For the best results we always recommend that the installation be
performed by a licensed professional.
Diverter Mounting
face of the stud
Figure i
crossbeam
1 3/8"
Figure ii
Hot
Flashlight
Triple Diverter Model
Pliers
Figure iii
Safety Glasses
Triple Diverter Model
Figure iv
Model Shown: ETHAN
1. Turn o all water supply lines and
drainage lines.
2. Clean the installation area
thoroughly and remove any excess
debris.
3. Secure the diverter 1 3/8" back from
the face of the stud, mounted on a
crossbeam. (Figure i)
4. Connect the diverter to the water
supplies using appropriate ttings. An
adaptor may be needed depending on
your piping. (Figure ii)
5. Depending on your model, connect
the shower head, hand shower, and
Cold
spout piping to the diverter. (Figure iii)
6. Finish the surrounding area before
proceeding to complete the diverter
installation.
7. Mount the cover plate to the
diverter. (Figure iv)
8. Install the handles and switches
with an allen key. (Figure v)
9. Please continue to the testing
section on the back side of this manual.
Figure v
Helpful Hint:
Always use Te on® tape or
other thread sealing tape on
water supply connectors to
prevent leaking. Do not use
plumber's putty or oil-based
sealant. We recommend
silicon caulking for sealing
drain ange and other parts.