Pearl Lynden Installation

Lynden
Installation
Introduction
Thank you for purchasing an authentic Pearl® faucet. The faucet you have
purchased is crafted out of the highest quality nickel, brass and stainless
steel. Each and every faucet was tested and carefully inspected by hand
before delivering to our retailers.
Please read the instructions carefully to prevent any malfunction and
damages to your plumbing and property.
Tools
The tools below are required to complete the installation. Some may not be
needed depending on the model of the faucet that you are installing. For
additional information, check with your local hardware store on the
requirements for your installation.
Philips Screwdriver Plumber's Putty
Thread Seal Tape Pliers
L i f e W i t h P e a r l . c o m
Connectors
Below are three di erent types of water supply line connectors that you may
have in your house. If you encounter a di erent type of connection that is
not listed below, please consult your local hardware store for more
information.
3/8"
O.D. Copper Tubing
With Bullnose Risers
Installation
The 3 holes required for this faucet should be no larger than 1-3/8"
Adjustable Wrench
O.D. Copper Tubing 3/8"
Without Risers IPS Faucet Connectors
1. Take both the left and right
handles.
2. Remove the top cap.
3. Using a Philip screwdriver,
undo the screw on top of each
handle. The top handle will come o
of the cartridge base. Unscrew to
the cover plate.
4. From the bottom, insert the
cartridge base up through the
counter.
5. Connect the counter plate to
the top side of the cartridge.
Installation
6. Attach the handle.
7. Using the screw and Philips
screwdriver, attach the screw back through
the handle.
8. Repeat these step for the other
handle.
9-10. Take the spout and remove the nut
and gaskets.
11-12. Place the spout into the counter.