Summary of Contents for Rico Version Solar-Log
- Page 1 Installation manual RiCo Ethernet-Converter Version Solar-Log™ November 2016 Firmware A1.00 Version 1.00...
- Page 2 Function The Ethernet Converter establishes a connection between a Solar-Log data logger and a RiCo large display. The Ethernet Converter communicates with the Solar-Log via the network interface (10/100 Mbit), using TCP. The Ethernet Converter and the Solar-Log must be in the same local area network and the same subnet. The Ethernet Converter receives the actual data from the Solar-Log (actual power, daily energy, total energy).
- Page 3 255.255.255.0 ___________________ Factor CO saving: 0.51 ________ Reading consumption values: no __________ TCP port: Output protocol: RiCo RS-485 9600 Baud 8N1 Serial number: _____________________ Configuration The following settings can be configured: • IP address Ethernet Converters • IP address Solar-Log •...
- Page 4 Fill in the necessary values in the corresponding fields. Take care to fill in correct values especially the fields IP address converter and subnet mask otherwise the converter will not be accessible again! At the input field for the factor of CO saving only the two digits after the decimal point can be entered.
- Page 5 The start-up is done in the following order: • If necessary change the configuration of the Ethernet Converter, described at page 4 of this manual and the RiCo large display, described at the manual of the display • Disconnect all devices from their power supply and do the installing corresponding to the connection scheme at page 6 •...
- Page 6 3: Data− ↔ Data− large display 4: +7.5V ↔ (+) power supply unit 7.5 VDC All mentioned trademarks and brands are the property of their respective owners. Manufacturer: RiCo Electronic Design GbR Glasbergweg 7 D-79822 Titisee-Neustadt Phone 07651 5848 info@rico-electronic.de www.rico-electronic.de...
Need help?
Do you have a question about the Version Solar-Log and is the answer not in the manual?
Questions and answers