Advertisement
This publication describes the installation procedure for the 4100-6030 Service Modem Card, and
Introduction
describes the difference between the service modem card and the CPU card service port.
This product is compatible with the 4100U and the 4100ES Fire Alarm Control Panel (FACP).
In this Publication
This publication discusses the following topics:
2005-2011 SimplexGrinnell LP. All rights reserved.
Specifications and other information shown were current as of publication and are subject to change without notice.
Simplex and the Simplex logo are trademarks of Tyco International Ltd. and its affiliates and are used under license.
Cautions, Warnings, and Regulatory Information
Introduction to the Service Modem
Installing the Service Modem
Software Modes
firealarmresources.com
4100-6030 Service Modem
Installation Instructions
Topic
See Page
2
4
5
6
579-194
Rev. E
Advertisement
Table of Contents
Related Manuals for Simplex 4100-6030
Summary of Contents for Simplex 4100-6030
- Page 1 2005-2011 SimplexGrinnell LP. All rights reserved. Specifications and other information shown were current as of publication and are subject to change without notice. Rev. E Simplex and the Simplex logo are trademarks of Tyco International Ltd. and its affiliates and are used under license. firealarmresources.com...
- Page 2 - Upon DO NOT INSTALL ANY SIMPLEX® PRODUCT THAT APPEARS DAMAGED unpacking your Simplex product, inspect the contents of the carton for shipping damage. If damage is apparent, immediately file a claim with the carrier and notify an authorized Simplex product supplier.
- Page 3 Simplex Time Recorder 100 Simplex Drive Westminster, MA 01441 U.S.A. declares that the Simplex Model 4100-6030 Service Modem Cards conform to the FCC’s specifications: Part 15: Operation is subject to the following two conditions: 1. This device may not cause harmful electromagnetic interference, and 2.
- Page 4 Introduction to the Service Modem Overview The 4100-6030 Service Modem is an option card that can be attached to the CPU board. The service modem provides support for remote access to PCs. Figure 1, below, is an illustration of the service modem.
- Page 5 Installing the Service Modem Overview This section describes the mounting procedure for the service modem, and a guideline as to how to connect to a computer. Mounting The service modem mounts on the CPU daughter card. Use the following instructions to mount the service modem to the CPU card.
- Page 6 Software Modes Overview The FACP can connect to PCs running important utilities, such as diagnostics, programming, CPU firmware downloading, and channel monitoring. It connects to PCs running all of these utilities via the service port on the CPU daughter card. When a PC is located remotely from the FACP, the 4100-9832 Service Modem is used.
- Page 7 Software Modes, Continued Software Modes Master Bootloader Interface Mode. This mode downloads the Master CPU Exec firmware and the CFG.TXT file to the CPU via the serial port. FigureTag FD9-194-03 serial download cable Laptop/PC running 4100 Panel Laptop/PC running terminal emulation software programming file transfer running Bootloader Figure 5.
- Page 8 579-194 Rev. E firealarmresources.com...
Need help?
Do you have a question about the 4100-6030 and is the answer not in the manual?
Questions and answers