Download
Share
Print this page
abco SureVAC 207422 Original Instructions Manual
  1. Manuals
  2. Brands
  3. abco Manuals
  4. Vacuum Cleaner
  5. SureVAC 207422
  6. Original instructions manual

abco SureVAC 207422 Original Instructions Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
POWERHEAD MANUAL
RE-ORDER CODE
207422
Original
Instructions

Advertisement

loading

Related Manuals for abco SureVAC 207422

Summary of Contents for abco SureVAC 207422

  • Page 1 POWERHEAD MANUAL RE-ORDER CODE 207422 Original Instructions...

  • Page 2: Table Of Contents

    Contents WARNING: Safety Instructions Parts List Assembly Operation Maitenance Troubleshooting...

  • Page 3: Warning: Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS! when using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS UNIT WARNING! To reduce the risk of fire, electric shock, or injury: • Close supervision is necessary when any appliance is used by or near children. Do not allow your Surevac Powerhead to be used as a toy or to run unsupervised at any time.

  • Page 4: Parts List

    Parts List DS1. Wheel cover plate DS20. Locating elastic part DS42G. Rotary handle assembly (back out) DS2. Front wheel DS21. Height adjusting wheel DS42-1M. Power cord DS3. C-Clip DS22. Number tape DS42-2G. Swivel neck DS4. Front wheel axle DS23. Ratchet wheel DS42-3H.

  • Page 5: Assembly

    Assembly Powerhead Assembly 1. Push the wand into the 2. Fix the cord to the wand. 3. Connect the wand with the swivel neck of the power hose handle and plug the cord head until it clicks into place. into the receptacle on the hose handle.

  • Page 6: Operation

    Operation The powerhead is designed with 5 height adjustment level. Choose an appropriate height level for different floor. Level 1 – shortest distance from the floor Level 5 – highest distance from the floor 3. Press the switch located in the hose handle to turn the powerhead on and navigate the powerhead back and forth to work.

  • Page 7: Maitenance

    Maintenance 3. Loop the new belt over the 4. Place the brush roller into the 5. Place the top cover and motor pulley first, and place bottom base with the round replace the 8 screws on the opposite end of the belt edge of the two end-caps the bottom.

  • Page 8: Troubleshooting

    Troubleshooting Resetting Circuit Breaker: 1. Disconnect unit from the electrical supply. 2. Remove any object that may have stalled the brush roll. 3. Rotate the brush roll by hand to make sure it is not frozen in position. 4. Push reset button downward until it snaps into its original position. 5.
  • Page 9 Service & Support 1800 177 399 service@abcopro.com.au...