Quadro Classic Quick Start Manual

ROLLER BLIND SYSTEM
SUNDRAPE ® -QUADRO
For the fixing of sundrape -Quadro roller
®
blinds on casement and window frames,
please use the attached screws (length:
13 mm). Check mounting site before
fixing. In some cases, the application of
shorter screws may be useful.
Please avoid any contact with the
glass pane!
In case of mounting between window
rabbet – especially when reflecting dra-
peries are placed very close to the glass
pane – there must be a sufficient venti-
lation between glass pane and drapery.
The attached mounting accessories for
sundrape -Quadro/s roller blinds gua-
®
rantee a sufficient ventilation due to
waste air circulation towards the top of
the blind. For roller blinds with foil dra-
pery at places without sufficient ventila-
tion, a minimum distance of 20 mm bet-
ween foil and glass pane is recommen-
ded.
Normal function is guaranteed in case
of operation with a declination up to
appr. 10 ° (i.e. normal declination of a
tilt pivot-hung window).
Roller blinds with cord operation do not
dispose of stopper plates for the upper
final position. Avoid rude and uncon-
trolled rolling up of the bottom bar
against the headbox. Otherwise, dama-
ges cannot be excluded.
SunTape side guiding:
The SunTape side guiding profiles are
guiding the drapery up and down and
avoid a slipping out of the drapery by
means of tapes placed at the selvage.
They resist to normal ventilation as cur-
rent of air. Should there be a mechanic
overstressing, for example obstacles in
the winding area etc., the tapes may slip
out of the guiding profiles. In this case,
please unwind the drapery completely
and insert tapes again carefully. In case
you don't succeed, remove cover profiles
and roll down drapery completely, then
wind up blind , afterwards, replace cover
profiles. A violent winding up of the dra-
pery will cause wrinkles.
For spare parts, please contact your
sundrape specialist.
®
Your sundrape partner
®
Operation • Use • Safety • Maintenance
sundrape - a registered trademark of Sundrape GmbH Im
®
Wiebusch 4-6 • 27607 Langen-Sievern • phone: +49.47 43 /
894-0 fax: +49.47.43/894-230 • e-mail: info@sundrape.com •
www.sundrape.de
ROLLER BLIND SYSTEMS