Sharp 32UF5 Operation Manual page 43

Operation of Universal Remote Control (Continued)
•
How to identify a DVD
The remote control may already be set to
operate your DVD. Try this initial check before
going on to the following "identifying" section.
(1) Slide CATV/DVD-TV/VCR switch to DVD.
(2) Point Remote towards DVD and press DVD/
VCR POWER.
(3) Does the Remote turn the DVD ON and OFF?
• If yes, the Remote is ready to operate the DVD
and no further steps are needed.
• If no, continue to the "identifying" section.
Direct Entry Method.
Refer to the following steps and list to quickly
find the remote control code for your accessory
DVD.
• First look up your DVD's remote control code
number before going through the Direct Entry
Method.
(1) Slide CATV/DVD-TV/VCR switch to DVD.
(2) Press and hold down INPUT and CH s on
your remote control.
Then release both buttons.
(3) Within 10 seconds after releasing INPUT and
CH s, enter your DVDs two-digit remote
control code number using REMOTE KEYPAD
(refer to the list).
• The remote control is now ready to send
commands to your DVD.
POWER
TV
TV
POWER
1
4
REMOTE
KEYPAD
7
FLASHBACK
PERSONAL PREFERENCE
A B
VOL
—
MENU
REW
PAUSE
DVD/VCR
DVD
POWER
VCR DISPLAY INPUT
INPUT
2 3
DISPLAY
5 6
8 9
ENTER
0 100
C D
CH
VOL
+
CH
CHANNEL
MUTE
UP (a)/
DOWN (s)
CATV TV
DVD VCR
CATV/DVD-
TV/VCR
PLAY FF
CH/SKIP
STOP REC
DVD BRAND
Denon
JVC
Magnavox
Marantz
Mitsubishi
Panasonic
Philips
Pioneer
Proscan
RCA
Samsung
Sharp
Sony
Toshiba
Yamaha
Zenith
Note:
Depending on the model, year produced,
brand, and type of DVD, some models may
not be compatible with the remote control.
REMOTE CONTROL
CODE NUMBER
02
09
04
04
06
02
04
08
03
03
07
01, 10
05
04
02
04
43