Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Ocean Matrix OMX-12BTMX0001
-
Page 2: Package Contents
4K HD video over a single CAT5e/6 cable. The OMX-12BTMX0001 also features 3x HDMI outputs for sending video to local displays, and supports uncompressed multi-channel audio, EDID management, and bi-directional IR and RS-232 control. -
Page 3: Specifications
Operating Instruction Features HDMI 2.0 Bandwidth Up To 18Gbps Supports Resolutions Up To 4K @60hz YUV 4:4:4 Transmits 4K Up To 40m, 1080p Up To 70m HDR10, 3D Support 1x HDBaseT In; 1x HDBaseT Out With 3x Looping HDMI Out ... - Page 4 Operating Instruction HDBaseT SPLITTER HDBaseT HDBaseT Equipped Equipped Receiver Receiver HDBaseT Equipped Receiver...
-
Page 5: Connection Diagram
Operating Instruction CONNECTION DIAGRAM HDBaseT Equipped Receiver HDBaseT Equipped Receiver... -
Page 6: Front Panel
Operating Instruction OPERATION CONTROLS AND FUNCTIONS Front Panel: 4 5 6 IR In: Connect the supplied IR Receiver cable for IR signal transmission. Place the IR blaster in direct line-of-sight of the equipment to be controlled. IR Out: Connect the supplied IR Emitter cable for IR signal transmission. Place the IR blaster in direct line of sight of the equipment to be controlled. -
Page 7: Button Instructions
Operating Instruction Button instructions: Pressing and releasing: Prompts three different EDID modes; Default EDID, Copy EDID and Priority mode 1). Default EDID mode: 4 different EDID types can be set according to the DIP switch. After setting, the HDBT IN indicator light will turn off and then return to normal operation. - Page 8 Operating Instruction IR pass through instruction: Two way IR pass though is only supported between Transmitter and Receiver units. Two way IR pass through between multiple repeaters is not supported. RS-232 pass through instruction: ID: Through a 4 PIN DIP Switch, Set the ID number on the 3rd and 4th bits. Upper means 0, Lower means 1.
-
Page 9: Product Service
Operating Instruction PRODUCT SERVICE Damage requiring service: The unit should be serviced by qualified service personnel if: (a) The DC power supply cord or AC adaptor has been damaged (b) Objects or liquids have gotten into the unit (c) The unit has been exposed to rain (d) The unit does not operate normally or exhibits a marked change in performance;...