Using The Ip27 - iHome The Portable System For Your iPhone & iPod iP27 Instruction Manual

Connect iP27 to Power Source
a) For home operation and to charge your iPhone or iPod, plug the AC adaptor cable into the AC Adaptor Jack and the other end
into a standard 120VAC wall socket. Adaptor must be plugged in to charge iPhone/iPod.
b) For portable operation, install 4 "AA" (LR6) batteries, 2 in each compartment on the bottom of the unit. Make sure polarity matches
diagram in compartments.
Setting the Clock
a) Depending on your location and the time of year, move the
compartment on the bottom of the unit to +1 to add one hour (a DST icon will appear on the display) or to -1 to subtract 1 hour.
b) Press and hold the Time Set Button until the display flashes. Press the
hour (standard) time display modes.
c) Press the Hour Button to adjust the hour setting (a PM indicator appears when time is set to PM; there is no AM indicator)
d) Press the Minute Button to adjust the minute setting. When the correct time is displayed, press the Time Set Button again. Two
beeps will indicate clock setting is complete.
Using the Alarm
Setting the Alarm
a) Press and hold the
is detected).
b) Press the Hour Button to set the desired alarm hour (a PM indicator appears when time is set to PM; there is no AM indicator)
c) Press the Minute Button to set the alarm minute time. When the desired alarm time is displayed, press the
Two beeps will indicate alarm setting is complete. Alarm is now armed, indicated by the alarm clock icon.
Arming and Disarming Alarm (Turn Alarm Function ON and OFF)
a) Press the Button to arm or disarm alarm functions. When armed, the alarm icon appears in the display.
Resetting the Alarm to Come on the Next Day
a) When the alarm is sounding, press the OFF Button to stop the alarm and reset it to come on the following day.
Snooze
a) Press the Snooze Button after the alarm sounds. The alarm will be silenced and come on again 9 minutes later. Snooze can be
pressed several times during the 1 hour alarm cycle.
Sure Alarm
The iP27 has a sure alarm feature: if the backup battery is installed, the buzzer alarm will still sound in the event of power failure.
iPhone/iPod
Playing and charging your iPhone or iPod
a) After selecting and placing the proper insert for your iPhone or iPod model, gently dock iPhone/iPod in Dock. When docked, the
iPhone or iPod will charge until fully charged when the iP27 is connected to an outlet with AC adaptor. Unit will not overcharge
iPhone/iPod.
b) Press the Button to play iPhone/iPod, and again to pause.
c) Press or Button to adjust iP27 volume up or down.
e) Press OFF Button to turn iP27 and iPhone/iPod off.

Using the iP27

Button until the alarm time flashes to wake to iPhone/iPod (buzzer alarm sounds if no iPhone or iPod
(Daylight Saving Time) switch located inside the left battery
Button to toggle between 24 hour (military) and 12
3
Button again.