King gates Open 424 Manual Instruction

King gates Open 424 Manual Instruction

Barrier 24vdc with encoder

Advertisement

Quick Links

OPEN 424
Open 424= Barrier 24Vdc with encoder
GB
MANUAL INSTRUCTION

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Open 424 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for King gates Open 424

  • Page 1 OPEN 424 Open 424= Barrier 24Vdc with encoder MANUAL INSTRUCTION...
  • Page 2 � � � � � ���� ���� � �...
  • Page 3 � � � � � � � ���� ��� �� � �� � � � � ���...
  • Page 4 TECHNICAL DATA Voltage (Vac 50Hz) (Vdc) Motor feed Motor power Motor consumption 230 Vac Torque (Nm) Insulation class Degree of protection IP 54 Jogging Intensive Operating temperature (°C) -20 / +70 Lubrication Permanent grease Opening time da 2 a 8 Weight (Kg) OVERALL DIMENSION...
  • Page 5 INSTALLATION BOX FIXING - Remove the anterior door “A” (image 2) getting access to the fixing holes onto the barrier’s base. - Fix the barrier on a plane base, or use the optional fixing plate (KING-gates code “BAO 200” ). BAR ASSEMBLY - Choose the desired closing direction to the bar (LEFT= images 4 and 6, or RIGHT= images 3 and 5).
  • Page 6 INSTALLATION PRELIMINARY CHECKS Read carefully all parts of this manual. Check that the product was not damaged during transportation. Check that the electrical plants is conforming to the characteristics required by the gear motor. Check that an adequate grounding plant exists and that all metallic parts are connected to this plant. A wrong installation can produce serious damages or wounds.
  • Page 7 ADJUSTMENT OF THE TRAVEL Unblock the barrier’s arm “As” turning the unblocking key “M1” (Figure 6) in counter clockwise sense (Slightly pushing the barrier’s arm, it must freely move for the whole 90° run). Using two 17 mm spanners, loosen the locking nut “D1” and screw in or out the adjusting screw “F1” until the desired horizontal stop position is obtained and then tighten the nut “D1”...
  • Page 8 MADE IN ITALY KING gates - Brand of Antoniolli Mario & C. s a s Via A. Malignani, 42 - 33077 Sacile (PN) ITALY Tel. +39 0434 737082 - Fax +39 0434 783382 e-mail: info@king-gates.com web: www.king-gates.com...

Table of Contents