Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for dji N1
- Page 1 N1 Video Encoder User Manual V1.0 2015.8...
- Page 2 This product and manual are copyrighted by DJI with all rights reserved. No part of this product or manual shall be reproduced in any form without the prior written consent or authorization of DJI.
-
Page 3: Product Profile
The AV or HDMI port on the encoder receives video input from the non-DJI camera to generate a live HD video feed in the DJI GO app. In addition, users may utilise the Micro USB port on the encoder to upgrade the firmware of various modules on the M100. -
Page 4: Installation
N1 Video Encoder User Manual You will require a 2.0mm hex key and foam tape to install the N1 Video Encoder onto the M100. If you are using HDMI IN, prepare an HDMI cable. If you are using AV IN, prepare a soldering iron, some solder and heat shrink tubing for wiring. - Page 5 10-pin Port 8-pin Port 4. Place the other end of the power and video cables near the mounting position of the N1 Video Encoder. 5. Re-mount the upper plate of the center frame, and tighten the 16 screws (M2.5x5). Orientate the upper plate so that the notch faces the left of the aircraft (with its tail facing you).
-
Page 6: Video Encoding
N1 Video Encoder User Manual 7. Connect the other end of the power and video cables to the power and video ports of the N1 Video Encoder. Power IN Video OUT The N1 Video Encoder only supports the DJI N1 Flight Controller. Please strictly follow the steps above to supply power to the device. - Page 7 DO NOT start the motors while upgrading the firmware. DO NOT use the N1 Assistant while upgrading the firmware. Only USB flash drives formatted with FAT32 or exFAT file systems are supported. Ensure that there is only one firmware upgrade package on your USB flash drive.
- Page 8 N1 Video Encoder User Manual Supported Video Inputs Source Video Formats PAL, NTSC 720p50, 720p60, 1080i50, 1080i60, 1080p25, HDMI 1080p30, 1080p50, 1080p60 Specificaitions Dimensions 65.2 mm × 45 mm × 10.7 mm Weight 31.4 g Operating Temperature -10° to 40° C...
- Page 9 This content is subject to change. Download the latest version from https://developer.dji.com/matrice-100 If you have any questions about this document, please contact DJI by sending a message to DocSupport@dji.com. © 2015 DJI. All Rights Reserved.
Need help?
Do you have a question about the N1 and is the answer not in the manual?
Questions and answers