Casio Privia PX-720 User Manual page 27

PREPARATION
• Before starting assembly of the stand, divide the
polystyrene foam packing material K into the sections as
shown in the illustration below. After dividing up the
material, you should end up with a total of six pieces
named K , K , and K
-( a ) -( b )
assembling the stand.
• If you do not have any packing material available for
some reason, use a magazine or some other thick item.
K
-(c)
1.
Place the digital piano onto the two K
foam pieces.
Bottom of the digital piano
Bracket
*
* Make sure that the edges of the brackets on either
side of the digital piano are positioned at the top of
the foam pieces.
B
, which you will use while
-( c )
K
-(a)
K
-(b)
-(a)
K
-(a)
K
-(a)
2.
Perform the following steps to attach side
panel A to the digital piano.
IMPORTANT!
• When inserting the corner of the side panel into the
bracket on the side of the digital piano in step (2-3)
below, take care to avoid damaging the side panel corner
( ). Never try to insert the side panel into the bracket
without first tilting the side panel at an angle as instructed
in step (2-2). Doing so creates the risk of damage of the
side panel corner.
(2-1) On side panel A , locate the corner that has a metal
piece attached to it, and then insert that corner
into foam piece K
(2-2) Tilt side panel A slightly as indicated by the
arrow in the illustration.
(2-3) Keeping side panel A tilted at an angle, carefully
insert the opposite corner ( ) into the bracket on
the side of the digital piano.
(2-3) (2-2)
Bracket
A
K
3.
Keeping side panel A tilted at an angle, align
the side panel with side of the digital piano.
(3-1) Push side panel A in the direction indicated by
the black arrow in the illustration to align the side
panel so there is as little space as possible between
its top edge A and the bottom of the top panel of
the digital piano ( ).
(3-2) After alignment is complete, stand side panel A
straight up so it is firmly against the side of the
digital piano.
Top panel of the digital piano
IMPORTANT!
• When performing step (3-1) above, make sure that you
position side panel A so its top edge reaches the bottom
of the digital piano top panel. If it does not, you will not be
able to stand side panel A straight up in step (3-2).
Assembling the Stand
.
-( b )
(2-1)
-(b)
(3-2)
A
(3-1)
K
-(b)
E-25