OFM 241 Quick Start Manual

Models 241 / 241-AA / 241-DK / 241-AA-DK
Parts Listing
A B
Large Washer
8x25mm Screw
4 Units 4 Units
D
C
Telescopic Bellows
Gas Lift
1 Unit
1 Unit
F
E
Chair Seat
Chair Back
1 Unit
1 Unit
H
Casters
5 Units
G
Chair Base
1 Unit
I
Seat Mechanism
1 Unit
E
I
B
A
C
G
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screw only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
24-Hour Task Chair
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Insert Casters (H) into Chair Base (G).
If you are assembling a model with a DK Foot Ring please proceed
STOP
to subsequent pages for drafting kit assembly instructions.
Step 2: Insert Gas Lift (C) into hole into Chair Base (G),
and cover Gas Lift (C) with Telescopic Bellows (D).
F
Step 3: Place Chair Seat (F) upside down on flat surface
and align the holes in the Seat Mechanism (I)
with the holes in the bottom of the Chair Seat (F).
Step 4: Place one Large Washer (B) on each of four
8x25mm Screws (A) and insert through holes in
the Seat Mechanism (I) into the Chair Seat (F).
Tighten with a screwdriver.
If you are assembling a model with optional Adjustable Arms please
STOP
proceed to subsequent pages for armrest assembly instructions.
Step 5: Insert Chair Back (E) into hole in the back of
D
Seat Mechanism (I). You may have to unscrew
the hand tension knob to allow plastic cover to
sit properly. Tighten hand tension knob to secure
Chair Back (E) into place.
Step 6: Place Chair Seat (F) onto Chair Base (G) by
inserting top of Gas Lift (C) into the hole in the center
of the Seat Mechanism (I). Push down on
Chair Seat (F) firmly to secure to Chair Base (G).
H