Pre-cast foundation with adaptor for ev charging station anchoring (5 pages)
Summary of Contents for Unimi Solutions 1baseHPC
Page 1
Introduction: Unimi-1baseHPC is intended for installation of larger rapid charging stations. By attaching an adaptor element at the top, each Unimi-1baseHPC can accommodate a wide variety of different chargers. The upward face and cable inlet of the adaptor element may look different from time to time depending on station model however the outer rectangular size and attachment pattern towards the Unimi-1baseHPC is always the same.
Measurements top view Installation procedure: 1. To off-load the Unimi-1baseHPC either use fork-lift for the EUR pallet on which the foundation is loaded or use a lift sling attached to the two lifting anchors positioned at either long side of the foundation.
Page 3
If integrated protection bollards shall be installed they can be attached on all sides of the Unimi- 1baseHPC via the 2xM16 concrete anchors. The protection bollards can be adjusted up and down alongside the foundation wall. Note that the attaching screws of the cylinders shall be just above ground surface to allow easy switch of damaged poles.
Page 4
Unimi K00717 Produktbeskrivning Kostnb. Dok namn Mallens filnamn Dok dat Aktuellt filnamn Gäller fr o m Godkänd Produktbeskrivning – Unimi-1baseHPC Produktbeskrivning.doc 2020-06-08 2014Draft01-...
Page 5
Unimi K00717 Produktbeskrivning Kostnb. Dok namn Mallens filnamn Dok dat Aktuellt filnamn Gäller fr o m Godkänd Produktbeskrivning – Unimi-1baseHPC Produktbeskrivning.doc 2020-06-08 2014Draft01-...