Advertisement
Solar LED Lanterns WT-F002-3 Specification
Operation Information
Maintenance
Scrap products
http://www.westechlighting.com
1.
Please read the instructions and fully charged before Use;
2.
Before plugging in an external battery or power supply, please make sure if the
power supply is correct;
3.
During the use process, when the LED lamp brightness get dimmed and batteries
become fully discharged state, in order to protect the battery，please stop using
and charge it in time at this time. Shouldn't charge after the LED lamp is completely
no light, because easily lead to excessive discharge battery failure extremely;
4.
Must use more than 8 hours every three months;
5.
Make the lamp off when not in use
6.
When the temperature is below 0 degrees or above 40 degrees, use and charging
efficiency will be reduced;
7.
Do not go near water or rain;
1.
solar panel surface clean
2.
The solar panel surface cannot be scratched and damaged.
1.
In order to reduce pollution of the environment, please do not throw the battery,
battery to a designated disposal agency or the designated bins.
Copyright ©2016 WESTECH. All Rights Reserved.
Advertisement
