Lamp Counter Reset; Security Settings - Sanyo PDG-DWL100 Owner's Manual

Password default
value is "1234" (first
time).
If you input incorrect
password 3 times, the
projector will automati-
cally shut itself down
and enter into standby
mode.
Volume:

■ Press the
■ Press the

Lamp Counter Reset

Reset the lamp life hour after replacing a new lamp.

Security Settings

Security Settings:

■ On: Choose "On" to enable security verification when turning on
the projector.
■ Off: Choose "Off" to be able to switch on the projector without
password verification.
Change Password:

■ First Time:
1. Press "ENTER" to set the password.
2. Use number buttons to enter default password and then press
"ENTER" to confirm.
3. Use number buttons on the remote to enter your new pass-
word and then press "ENTER" to confirm. (The password has
to be 4 digits.)
4. Enter new password again and press "ENTER" to confirm.
■ Change Password:
1. Press "ENTER" to input old password.
2. Use number buttons to enter current password and then press
"ENTER" to confirm.
3. Enter new password (4 digits in length) using the number but-
tons on the remote, then press "ENTER" to confirm.
4. Enter new password again and press "ENTER" to confirm.
Factory Default
Return the adjustments and settings to the factory default values.
(except for lamp counter and security setting)
User Controls
to decrease the volume.
to increase the volume.
29
English
English