INNR Smart Button RC210 Instructions

Connect your Innr Smart Button to Philips Hue
Step 1: Connect the Smart Button to the Philips Hue Bridge
Hue
PHILIPS
Searching
for lights...
Open the Philps Hue app and
start the searching for lights.
*No blinking LED? Press and hold the reset button behind the battery lid for 3 seconds.
Step 2: Connect the Smart Button to the individual lights
on
Turn the light off for at least
5 seconds using the wall switch
and turn it on again. The light is in
pairing mode for 1 minute from now.
Repeat Step 2 for all lights that you want to connect to the Smart Button.
You can now control the connected light(s) from the app and with the Smart Button.
Successful!
Remove the plastic tab to put the
Remote Control in pairing mode.
The LED on the front will start
blinking once per second.*
Press the Smart Button 3 times in
quick succession and hold the third
press for 3 seconds.
The LED on the Smart Button will
blink once per second.
The LED will rapidly blink twice
to confirm it's successfully
connected.
NOTE: the Smart Button will not
appear in the Philips Hue app.
Bring the Smart Button close to
the light (< 10cm).
The light will blink to confirm it's
successfully connected.