Sanyo Xacti VPC-HD1A Instruction Manual page 119

EDITING VIDEO CLIPS
5
Specify the start point of the extract.
h Use the procedure below to specify the frame from which the video
clip extract will start.
h Play the video clip until approximately the desired point, pause the
video clip, then play the video clip one frame at a time, stopping at the
start point of the extract. This will be the first frame of the extract.
h If the start point of the video clip is also the start point of the extract,
proceed to step 6.
<Procedure>
Play:
After pausing playback, press and hold the SET button to the right for
about 2 seconds for forward playback, or to the left for reverse
playback.
Pause:
During playback, press the SET button.
Accelerated playback:
During playback, toggle the SET button to the left or right to change
the playback speed.
Single frame:
After pausing playback, toggle the SET button to the right to move
forward one frame, or to the left to move back one frame.
6
Toggle the SET button up.
h The start point of the video clip
extract is set, and the screen to
specify the end point appears.
h Specify the end point of the extract
by following the same procedure as
in step 5.
<When joining the first and latter
portions>
1 Toggle the SET button down.
h The portion to be deleted
switches to the extracted
portion.
h Each time the SET button is
toggled down, the sections to
denedj/ .0035 Tc[(P6(p)8.96c[(P6(p)8.961.1552 (ontT[(po6o1.224466w[(t.,-1.
1
105
English