Nitelighter NLS650M Important Safety Instructions

!
Do not allow children to install or operate the light.
!
Do not install the light in poor weather conditions, especially when lightning is present.
!
Ensure the area where the light is being attached is free from wires, plumbing or other
obstructions.
!
If using a ladder, ensure the footing is secure before climbing and obtain assistance when
needed.
!
Wear protective equipment such as safety glasses, dust masks and gloves when installing
the light.
!
Ensure the area where the light is being installed is structurally sound and will support the light.
!
Do not hang anything from the light.
!
Clear any snow or other objects from resting on top of the light.
IMPORTANT: Ensure that the location of where the
light will be installed allows for adequate sunlight
throughout the day to charge the battery sufficiently. Be
mindful of overhangs or shaded areas.
1. Unfold the light and remove any packaging.
2. Remove the mounting plate from the solar panel by
pulling down on the plate and up on the light/panel.
3. Place the plate in the desired area, ensure the plate
is level and mark the hole locations.
4. Predrill the marked holes with an appropriate sized
drill bit (mounting surface will determine the drill bit
required).
NOTE: The surface on which the light is being mounted
will determine the type of installation required. Masonry
surfaces such as brick or concrete will require the use of
a masonry bit and plastic anchors/screws. Installation
into a wooden surface or some engineered surfaces may
only require the use of the provided screws. Longer
screws may be required depending on the installation.
Motion-Activated Solar Powered LED Spotlight
with Light Sensor
Model: NLS650M
IMPORTANT: Keep this manual for future reference.
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Installation
™