Battery Replacement; Product Specifications - Tarmo 321961 Manual

EN
CROSS-LINE LASER WITH TRIPOD
Before using the device, read this manual carefully and keep
it for future reference. Failure to follow safety instructions may
cause damage to the device or bodily injuries.
1. On/off switch
2. Lock switch for self-levelling function
3. Battery compartment cover
4. Threaded hole for tripod
WARNING: Do not look directly at the source of laser beam.
Follow the safety instructions below.
1. Do not modify the device.
2. Use the laser device in accordance with these instructions.
3. Do not intentionally point the laser beam at people or animals.
4. Do not point the laser beam at bystanders' or animals' eyes.
Laser radiation may damage your vision.
5. Always make sure the laser beam is not directed at reflec-
tive surfaces. A reflective surface may project the beam at oper-
ator or bystanders.
6. Do not allow children to operate the device. Do not allow chil-
dren in the working area when setting up and using the device.
7. When it is not in use, store the device in a dry place, beyond
the reach of children.
8. Do not replace the laser unit with another type of laser unit.
Laser level
The laser beam is visible and emitted from the laser aper-
ture. The laser pointer used in the device is Class I and com-
plies with the EN 60825-1:2014 standard. Do not take the laser
module out of its casing, as this will change the laser classi-
fication.

Product specifications:

Self-levelling accuracy
Self-levelling angle
Range
Operating temperature
Laser class
Laser wavelength
Laser power
Battery type
Dimensions
321961_ristilinjalaser_ko_fi-sv-en-et-lv-lt-ru_A5.indd 3
1
1.
2
2.
3.
4
4.
± 0,5 mm/m
5°
10 m
0–45 °C
1
630–670 nm
< 0,39 mW
1.5 V AAA batteries (x 2)
68 x 65 x 58 mm
Tarmo Finland, PO Box 499, FI-33101 Tampere, Finland/ Тампере, Финляндия
The device is used for the precise setting of horizontal and
vertical lines. Observe the following instructions when work-
ing to ensure the optimal operation. Use other than described
below is not allowed and may cause damage to the product.
3

Battery replacement

- Carefully pull the cover latch in order to unlock the battery
compartment cover (3).
- Insert 2 new AAA batteries, observing the correct polarity.
- Close the cover. Make sure the latch snaps in place.
Self-levelling function
- The laser has a self-levelling function. The function is opera-
tional within ±5° of the laser tilt angle.
- Switch the laser on and slide the lock switch for self-levelling
function (2) to the unlocked position.
- When the laser tilt angle does not allow the self-levelling
function to work (angles greater than 5°), the laser will sig-
nal the problem by flashing the red indicator light next to the
on/off switch (1).
- Set up the laser in a position so that the indicator light does
not flash: only then it will be possible to set vertical and hor-
izontal lines.
- Press the on/off switch (1) to toggle between showing the
horizontal line, vertical line and both.
- To switch the laser off, slide the lock switch for self-levelling
function (2) to the locked position.
321961
ko0519
Info/ Tootja/ Ražotājs/ Gamintojas/ Изготовитель:
28.5.2019 9.32.11