Advertisement
Table of Contents
CLIPPER CHARGE STAND ADAPTER USE INSTRUCTIONS
INSTRUCCIONES DE USO DEL ADAPTADOR DE BASE
DE CARGA DE LA CORTADORA
INSTRUCTIONS D'UTILISATION DE L'ADAPTATEUR
DE SUPPORT DE CHARGE DE LA TONDEUSE
© WAHL CLIPPER CORPORATION
Sterling, IL USA
FORM #93255-500
Printed in USA
ADAPTER ONLY TO BE USED WITH WAHL CLIPPER CHARGE STAND. CHARGE STAND ONLY TO BE
USED WITH WAHL CORD/CORDLESS CLIPPERS AND POWER SUPPLIES.
WHEN TO USE THE ADAPTER
If your WAHL cord/cordless clipper has model #ZD018B040200 or model #S010AZM0400200 power cord,
you will need to use the adapter. (Refer to Figure A)
MODEL#
FIGURE A
1. Attach the power cord plug into the large adapter end.
2. Insert the small adapter end into jack located on the back of the clipper charge stand.
WHEN NOT TO USE THE ADAPTER
If your WAHL cord/cordless clipper has model #ZDO18B050200 power cord, you do not need the adapter.
(Refer to Figure A)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Wahl ZD018B040200
- Page 1 2. Insert the small adapter end into jack located on the back of the clipper charge stand. WHEN NOT TO USE THE ADAPTER If your WAHL cord/cordless clipper has model #ZDO18B050200 power cord, you do not need the adapter. (Refer to Figure A)
- Page 2 CARGA SOLO DEBE USARSE CON CORTADORAS INALÁMBRICAS Y CABLE Y FUENTES DE ALIMENTACIÓN WAHL. CUÁNDO USAR EL ADAPTADOR Si su cortadora con cable o inalámbrica WAHL tiene un cable de alimentación modelo #ZD018B040200 o modelo #S010AZM0400200, deberá usar el adaptador. (Consulte la Figura A) N.° DE MODELO FIGURA A 1.
Need help?
Do you have a question about the ZD018B040200 and is the answer not in the manual?
Questions and answers