Salsbury Industries S-54000 Series Installation Instructions

15" Wide See-Through Lockers – S-54000 Series
Thank you for selecting Salsbury's 15" wide see-through four tier lockers. These instructions are intended to assist you in assembling the lockers. Assembly of the various locker
components will be with #10 - 24 x 3/8" long slot less screws and #10 nuts (provided). Loosely fasten a screw and a nut into every set of mating holes with the screw heads positioned on
the outside of the locker or on the exposed surface.

One Wide Locker Assembly

Step 1: Attach the top shelf and bottom shelf to the back panel.
Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the
first side panel, the left rear leg, and three compartment dividers to the assembly from
Step 1.
Four Tier Installation Instructions
Step 3: Attach the second side panel and the right rear leg to the assembly of Step 2.
The locker chassis is now complete.
Step 4: Attach the pre-assembled door frame onto the assembly of Step 3.
Step 5: Tighten all fasteners checking for squareness of the locker while tightening.
Attach optional sloping hood, end bases or front base (see pages 4 and 5).
Step 6: Place the locker in the installed location and anchor to the floor, wall, or to
both. Individual job conditions will dictate the type of fastening anchors to use (not
provided).
Step 7: Fasten all lockers in a row together by installing fasteners provided through
the side panels. Installation is now complete.