1. Manuals
  2. Brands
  3. Mr. Blacksmith Manuals
  4. Impact Driver
  5. 9009432
  6. Owner's manual

Mr. Blacksmith 9009432 Owner's Manual

1/4”
Hide thumbs Also See for 9009432:
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
1/4"Impact Driver
Owner's Manual
Manuel d'utilisation
WARNING:
Read carefully and understand all ASSEMBLY AND OPERATION
INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety
precautions may result in serious personal injury.
ATTENTION:
Lisez attentivement et comprenez toutes les INSTRUCTIONS D'ASSEMBLAGE
ET D'UTILISATION avant l'utilisation. Le manque de suivre les règles de sécurité et d'autres précautions de
sécurité basiques peut avoir comme conséquence le dommage corporel sérieux.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 9009432 and is the answer not in the manual?

Questions and answers

Summary of Contents for Mr. Blacksmith 9009432

  • Page 1 1/4”Impact Driver Owner’s Manual Manuel d'utilisation WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. ATTENTION: Lisez attentivement et comprenez toutes les INSTRUCTIONS D'ASSEMBLAGE ET D'UTILISATION avant l'utilisation.

  • Page 2: Intended Use

    READ & SAVE THESE INSTRUCTIONS LIRE ET CONSERVER CES INSTRUCTIONS Intended Use The machine is intended for driving in and loosening screws and bolts as well as for tightening and loosening nuts within the respective range of dimension. Technical Specifications Property Specification Battery Rating...
  • Page 3 Functions Operating Instructions Tool Set Up TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Make sure that the Trigger is in the off-position and remove its Battery Pack before performing any procedure in this section. Battery Charging Charge battery after unpacking and before using this tool. Follow instructions included with battery charger.
  • Page 4 Attaching/Removing Accessories CAUTION! Only use 1/4" hex shank bits designed for impact use. Verify bit fits the Chuck precisely before use. 1. Pull Collar forward and insert an appropriate impact-rated accessory (sold separately) into the hex drive Chuck. Pull on bit to ensure it is secure. 2.
  • Page 5 Install bit and select direction of rotation. NOTICE: Do not change direction of rotation while Chuck is rotating. Wait until Chuck has come to a complete stop before changing direction. Press Trigger to start the tool. The Work Lights will turn on when Trigger is pressed and turn off a few seconds after Trigger is released.

  • Page 6: Troubleshooting

    Troubleshooting Use the table below to troubleshoot problems before contacting service personnel or your local dealer. If the problem continues after troubleshooting, call your local dealer for assistance. Failure Possible Cause Corrective Action Remove Battery Pack, make sure there are no obstructions, clean battery contacts on tool, reinsert the Battery Pack not properly connected.

  • Page 7: Parts Diagram

    Parts Diagram Parts List Part Number Part Description Quantity Shield Screw...
  • Page 8 Part Number Part Description Quantity Screw Spring Washer Transparent Cover LED Circuit Board Jump Ring Spacer Spring Collar Aluminum Shell Shaft Sleeve Steel Ball Spacer Output Shaft Steel Ball Impact Block Steel Ball Spacer Inner Gear Ring Spring Main Shaft Planetary Gear Spacer Bearing...
  • Page 9 Part Number Part Description Quantity Rear Block Push Rod Housing Screw 20 V Battery Pack Battery Terminal Switch Assembly Nameplate Belt Clip...

Table of Contents