Advertisement
•
Do not insert needles.
•
Do not use when folded or crumpled.
•
Do not use when the device is wet.
•
Do not pull on the cables. Make sure that the cable is not twisted or broken.
•
Please check the foot warmer as well as the power cord regularly for signs of wear or damage.
If there is any damage or the device malfunctions, do not use it any longer.
•
When the foot warmer is switched on, the following requirements must be met:
Do not place any objects on the heating pad.
o
Heat sources such as hot water bottles, foot warmers etc. are not permitted to be placed
o
on the heating pad.
The electronic components in the controller heat up when the foot warmer is in opera-
o
tion. For this reason, the controller must never be covered or placed on the foot warmer
when it is in operation.
Control panel
Illuminated display for temperature settings
Commissioning
•
Make sure that the foot warmer is neither kinked nor folded during use.
•
Plug in the plug to the mains.
•
In case you wish to use the foot warmer during several hours, it is advisable to set it to the
lowest possible temperature. Thus, you will avoid being too hot without noticing it when sleeping.
•
When the foot warmer is not in use, set the switch to off position to switch it off, then disconnect
the plug from the mains.
Cleaning and maintenance
•
Always disconnect the mains plug from the socket before cleaning.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Temperature setting switch
On/Off switch
Item 62902
Seite 4
01
2022-1
Advertisement
