Download Print this page

Millennium T3669-80A Assembly And Installation Manual

Monument above ground delta extruded wall oval pools with 7” frames

Advertisement

Quick Links

Your pool contains a large quantity of water, and is deep enough to present inherent dangers to life and health unless the follow-
ing safety rules are strictly observed. First-time users run the highest risk of injury. Make sure everyone understands. To insure
your pool is used safely you
The top rail of your pool is not a walkway and must not be used for jumping or diving. Do not
permit jumping or diving into the pool from a deck or the top rail of the pool. Diving or jumping
into the pool can result in serious injury.
Never permit the pool to be used unless it is attended by at least one person other than the
bather. Someone should always be available to lend assistance in an emergency.
Never leave a child alone and unsupervised in or near the pool—not even for a second. There
is no substitute for constant adult supervision.
Do not permit "rough-playin" in and around your pool. Surfaces can become slippery and
hazardous when wet.
If the pool is used after dusk, adequate lighting must be provided. Illumination in the pool area
must be sufficient to clearly judge pool depth and all features in and around the pool. For light-
ing recommendations, consult your local licensed electrical contractor
Do not leave chairs or other furniture beside the pool that could be used by a child to climb
up into the pool. Ladders must be removed whenever the pool is unattended. A fence with a
lockable gate around the pool or yard is strongly recommended and may be required by law in
some jurisdictions.
Never drink alcoholic beverages or use any intoxicants which could hinder your judgment and
reflexes.
Your filter system will remove suspended particles from the water and the surface skimmer
will remove insects, leaves and other debris from the water surface. Use the correct pool
chemicals as directed to destroy harmful bacteria and prevent formation of algae. Remember,
unsanitary water is a serious health hazard.
Read and follow all safety instructions packaged with pool, ladder, deck or any other accessory.
Additional pool safety publications can be obtained by contacting: The Association of Pool &
Spa Professionals (www.apsp.org)
The safety stickers must be installed as per following instructions. Failure to properly install warning labels will void warranty.
Failure to mount these safety labels may subject you to substantial liability in case of injury. These warning are not to be re-
moved under any circumstances! If they become discolored or fall off please request replacements which will be sent at no
charge.
FAILURE TO HEED THESE WARNINGS CAN RESULT IN PERMANENT INJURY,
PARALYSIS FROM A BROKEN NECK, ELECTROCUTION OR DROWNING.
THIS POOL IS NOT DESIGNED FOR DIVING OR JUMPING!
DANGEROUS INJURY CAN RESULT, SHALLOW WATER!
observe the following safety precautions:
.
Do not walk on top ledges. They can be slippery and they are not a walkway.
The cover must have a tamperproof locking retainer cable that positions the cover around the
pool wall and keeps it securely in place. Never allow anyone, especially small children on the
cover. Asphyxiation or drowning could result. When purchasing any pool cover, please consult a
swimming pool professional.
Never touch or attempt to service electrical equipment, including the filter when your body and/
or the ground is wet. Electrocution or permanent injury due to high voltage (120V AC) could
result. The pool should be bonded in accordance with Section 680-26 of the National Electical
Code. For further assistance contact your dealer or a local licensed electrician. Do not use pool
during electrical or rain storms.
Keep a safety rope 1/4" by 50" with a flotation buoy with an outside diamter of 15". Have ac-
cessible in a prominent area by your pool. Keep a pole not less that 16 feet (4,88m) long with a
blunt or hook end available at pool side in case of emergencies.
.
Do not place chlorine, chlorine tablets or sticks directly into skimmer, or winterize your pool with
liquid chlorine. Damage to the skimmer, pool liner and filter will result. Failure to obey this in-
struction will void all component warranties. Always follow Chemical Manufacturer's insturctions
when storing, handling and dispensing pool chemicals.
Periodically check your pool and ladder components for damage and wear. Be sure all screws
are in place. Replace all damaged or worn components and tighten all screws before you use
the pool, deck or ladders. At first sign remove rust and touch up immediately.
Never modify the pool or accessories, or remove or drill holes in the pool, deck or ladder com-
ponents unless instructed. Your pool wall is made of thin metal, there is an inherent cut hazard
with metal so use gloves during installation. Always use Original Equipment Manufactured parts
for your replacement parts.
R.12/11

Advertisement

loading
Need help?

Need help?

Do you have a question about the T3669-80A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Millennium T3669-80A

  • Page 1 FAILURE TO HEED THESE WARNINGS CAN RESULT IN PERMANENT INJURY, PARALYSIS FROM A BROKEN NECK, ELECTROCUTION OR DROWNING. THIS POOL IS NOT DESIGNED FOR DIVING OR JUMPING! DANGEROUS INJURY CAN RESULT, SHALLOW WATER! Your pool contains a large quantity of water, and is deep enough to present inherent dangers to life and health unless the follow- ing safety rules are strictly observed.
  • Page 2 T3669-80A POOL ASSEMBLY AND INSTALLATION MANUAL Monument Above Ground Delta Extruded Wall Oval Pools with 7” Frames Note: Deck and fence accessories shown are optional. THIS MANUAL EXPLAINS THE CO RRECT ME THOD TO ASS EMBLE YOUR NEW SWIMMING POO L. REA D THESE INSTRUCTI ONS AND STUDY THE ILL USTRATIONS.
  • Page 3 DANGER 1. DO N OT DIVE OR JUMP INT O YOUR POOL . DO N OT USE A P OOL SLIDE O N THIS P OOL. YOUR POO L CO NTAINS SHALLOW WATER AND IS NOT DESI GNED F OR HEAD FIRST ENT RY (D IVING OR S LIDING) O R J UMPING. DIV ING, S LIDING OR J UMPING CA N RESULT IN A BROKEN NECK IF YOU STRIKE THE POOL.
  • Page 4: Ground Preparation

    5. ADDITIONAL POOL SAFETY RELATED PUBLICATIONS ARE AVAILABLE FROM THE FOLLOWING: ASSOCIATION OF POOL & SPA PROFESSIONALS CONSUMER PRODUCT SAFETY COMMISSION 2111 EISENHOWER AVE WASHINGTON, DC 20207 ALEXANDRIA, VA 22314-4695 IMPORTANT INSTALLATION ITEMS 1. LEVELNESS; POOL MUST BE LEVEL WITHIN 3/4”. UNLEVEL POOLS PLACE EXTREME FORCES ON THE POOL WHICH MAY DEFORM. 2.
  • Page 5 Step 1: P arts Id entification: See figures in bill of material LEVEL packet. Che ck fo r in stallation LINE 3 addendums. Step Ground Layout: Layout the area to be leveled as LINE 5 shown in Fi gure 1. Me asure DIAGONALS and ma rk wit h spray pain t the lines on the ground for your size...
  • Page 6 Step 3: Attach t he left and right sides of the delta uprights to the DELTA UPRIGHTS bottom beams as shown in Figure 3. Slide the tee clip through the slot in the bottom rail and attach t o the top of the bottom beam as shown in FIGURE 3 BOTTOM...
  • Page 7 Step 7A: Assemble the adapter to the mud-sill as shown in Figure 6A. Step 8: Attach the delta stiffeners to t he stiffener bracket as shown in Fi gure 7. You will need to slid e the sho rt delta interlocks onto the left and right deltas to be just above the stiffener brackets. FIGURE 6 L00053 3/8”...
  • Page 8 BOTTOM RAIL 12X OVALS – SHORT WALL Step 10: S ee Fig ure 9 and 10. CHANNEL (43 7/16”) Place the req uired amount of sand ADAPTER 15X & 18X OVALS – SHORT inside the p ool area. Pla ce the 3’ WALL CHANNEL (52 13/16”) angles into the slot in the bottom rail as shown in Detail 8A.
  • Page 9 MIDSECTION SLAT COUNT FIGURE 11 MUD SILLS BOTTOM W00049 RAIL TRANSITION UPRIGHT TRANSITION UPRIGHT 15 x 30 pool size 12 x 18 12 x 21 15 x 24 18 x 33 pool size number of slats On the round ends there are 11 slats between the upright slats. Except Upright Slat for the 12x18 &...
  • Page 10 DUCT TAPE CURVED BEAD RECEIVER BEAD LONG BEAD RECEIVER RECEIVER(S) WALL SAND SLATS WARNING: Failure to use th e san d or sand equivalent a nd shape it as specified will void all warranties o n the pool RETURN SLAT SKIMMER SLAT and liner.
  • Page 11 Step 16: Se e Figu re 1 8. Remove the liner from th e ca rton and unfold into t he po ol. Be ca reful not t o dra g, abrade o r sn ag the line r. Spread th e liner o ut over t he entire b ottom of the pool. The lin er bottom should b e centered in the pool using the seam at the perimete r of the bottom as a guide .
  • Page 12 FIGURE 22 CO00022 #10 – 24 x 5/8” CARRIAGE BOLTS STRAIGHT SIDE COPING DELTA TOP CLIP #10 – 24 HEX NUT #12 x ½” SS TYPE AB HEX HEAD WASHER Note: Attach the midsection HEAD SELF-TAP FIGURE 21 (4 PER TOP CLIP) coping to the delta top clips first, then attach the coping and C000012B...
  • Page 13 POOL WALL SKIMMER ASSEMBLY TEFLON TAPE TELFON TAPE LINER HOSE HOSE ADAPTER ADAPTER FACE LOCKNUT PLATE GASKET FACE PLATE SCREW FIBER FACE WASHER PLATE LINER SANDWICH FIGURE 24 GASKET POOL WALL W00024 RUBBER GASKET WALL FITTING RETURN ASSEMBLY DIRECTIONAL BALL DIRECTIONAL BALL (POINT OPENING AWAY FITTING...