Maintenance - Panasonic ER-CNT1 Operating Instructions Manual

Maintenance

• Make sure that the main body is turned off.
• After cleaning, be sure to store with the blades, the
trimmings box and the protective cap attached.
How to clean
► W ith water
1. Apply some hand soap and some water to the outer blade.
2. Turn on the power and turn off the power after 10 seconds. (Fig. 7‑1)
▼
To remove light dirt
3. Open the water inlet and
turn on the power again.
▪ If the trimmings box is
removed, open the water
inlet after attaching the
trimmings box.
4. Run water down the water
inlet (Fig. 7‑2), rinse well
and turn off.
▼
5. Wipe off the water with a dry cloth and dry it well.
▪ It will dry faster with the blades and the trimmings box removed.
Notes
• Note the following precautions to avoid malfunction and damage.
• Do not use hot water or any detergents other than hand soap.
• Do not wipe with thinner, benzine, alcohol etc.
8
▼
To remove heavy dirt
3. Remove the head,the blades
and the trimmings box.
4. Rinse them with running
water. (Fig. 7‑3)
• Cover the drainage outlet
of washbasin to prevent
the inner blade from
flowing away.
▼
► W ith the cleaning brush (Fig. 8)
1. Remove the head, blades and the trimming box.
2. Brush off any hair trimmings from the head, blades and the
trimming box.
▪ Be careful not to deform the inner blade.
▪ Be careful not to damage the filter.
How to open and close
the water inlet
► O pen
Rotate the wash switch ring until its "
" " mark of the head to open the water inlet. (Fig. 9‑1)
► C lose
Rotate the wash switch ring until its "
" " mark of head. (Fig. 9‑2)
Removing and mounting
the trimmings box
► R emove (Fig. 10‑1)
Rotate the wash switch ring until its "
" " mark of the head.
► M ount (Fig. 10‑2)
1. Align the " " mark of the trimmings box with the "
of the head.
▪ Be careful not to damage the filter with the shaft (c).
2. Rotate the wash switch ring until its "
the " " mark of the head.
" mark aligns with the
" mark aligns with the
" mark aligns with the
" mark
" mark aligns with