Related Manuals for Lyngdorf LS-1000
Summary of Contents for Lyngdorf LS-1000
- Page 1 LYNGDORF LS-1000 INSTALLATION MANUAL (working document) LYNGDORF AUDIO LS-1000 LS-1000 Left, LS-1000 Right, LS-1000 Center LS-1000 INSTALLATION LS-1000 Center MANUAL [Skriv tekst]...
-
Page 2: Table Of Contents
TABLE OF CONTENTS COMPLIANCE ..................... 3 PRE-INSTALLATION ................... 4 SPEAKER INSTALLATION ................. 7 4 X LS-1000 LEFT/RIGHT CUT-OUT DIMENSIONS ........10 4 X LS-1000 CENTER CUT-OUT DIMENSIONS ..........11 TECHNICAL SPECIFICATIONS ................ 13 SERVICE INFORMATION ................. 14 Lyngdorf Audio LS-1000 – Installation manual... -
Page 3: Compliance
Steinway Lyngdorf products and accessories comply with parts 15 and 68 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference; and (2) this device must accept any interference received, including any interference that may cause undesired operation. -
Page 4: Pre-Installation
Contact both the shipper and your local Lyngdorf Audio representative immediately if the unit bears any sign of damage from mishandling. In some cases, it may be necessary to return the equipment to Lyngdorf Audio or an authorized service provider for repair; therefore, it is recommended that you save your original packing materials. - Page 5 Mounting screws for top, base and side brackets Prepare the Wall for the Speaker Stacks For proper mounting of a Lyngdorf LS-1000 Left, Center or Right loudspeaker stack, a rectangular cutout with the following dimensions must be made in the wall:...
- Page 6 Arranging the speaker units Arrange the individual LS-1000 units on the floor, ready to combine them as a stack. For each loudspeaker stack, place the loudspeakers with the back side down on the floor, preferably close to the wall cutout in which the stack is to be mounted.
-
Page 7: Speaker Installation
Remove the Side Brackets from Each Speaker Unit All Lyngdorf LS-1000 loudspeaker units are equipped with POM thermoplastic side brackets from the factory. When these brackets are mounted correctly on the left, right, and rear sides of the units, they align and secure the individual units in a stack to each other. - Page 8 Connect the Loudspeaker Cables Connect and tighten the speaker cables to the base plate of the first LS-1000 speaker. Make sure the cable ends are securely tightened and no bare wire is standing out.
- Page 9 NOTE! For your own safety, do not attempt to raise the stack by yourself. There should be one person involved in lifting a loudspeaker stack for every two loudspeaker units in the stack; so a stack of 4 x LS- 1000 loudspeaker units requires at least two people to lift. Lyngdorf Audio LS-1000 – Installation manual...
-
Page 10: Ls-1000 Left/Right Cut-Out Dimensions
4 X LS-1000 LEFT/RIGHT CUT-OUT DIMENSIONS 290 mm 290 mm / 11.4” / 11.4” 2085 mm / 85” 2085 mm / 85” Lyngdorf Audio LS-1000 – Installation manual... -
Page 11: Ls-1000 Center Cut-Out Dimensions
4 X LS-1000 CENTER CUT-OUT DIMENSIONS 290 mm / 11.4” 2085 mm / 85” Lyngdorf Audio LS-1000 – Installation manual... - Page 12 Example of finished LS speaker system with 4 x LS-1000 each for left, center, right channel Lyngdorf Audio LS-1000 – Installation manual...
-
Page 13: Technical Specifications
4 pcs 115 mm, 25mm voice coil, aluminum cone, vented magnet Enclosure: Frequency range: 100 – 20.000 Hz (-3 dB) (for four LS-1000 modules) Frequency extension down to 50 Hz depending on EQ Nominal Impedance: 4 Ohm (for four LS-1000 modules) (16 Ohm per module) Sensitivity: 98 dB (2.83 V/1 m) (for four LS-1000 modules) -
Page 14: Service Information
DK 7800 Skive Denmark In some cases, it may be necessary to return the equipment to Steinway Lyngdorf or an authorized service provider for repair; therefore, it is recommended that you save your original packing materials. Steinway Lyngdorf will not be responsible for any damage due to unauthorized packing or shipment in non-original packing materials. - Page 15 Lyngdorf Audio LS-1000 – Installation manual SL AUDIO A/S • ULVEVEJ 28 • 7800 SKIVE • DENMARK • WWW.STEINWAYLYNGDORF.COM...
Need help?
Do you have a question about the LS-1000 and is the answer not in the manual?
Questions and answers