Summary of Contents for G-Scale Graphics LRS-150-24
- Page 1 Operation and Installation Manual G-Scale Graphics 5860 Crooked Stick Dr. Windsor, CO 970-581-3567 GScaleGraphics@comcast.net www.GScaleGraphics.net Revision New: Updated 12/4/2020 Page...
- Page 2 Power supply voltage will determine your maximum speed. We recommend: Meanwell LRS-150-24 (24V, 6.5A) available from multiple on-line sources for about $18 Note: Keep in mind that most locomotives only require about 1 amp while running. A power supply capable of 3-5 amps is usually more than enough for most applications.
- Page 3 Turn on power supply. Set speed with the knob and direction with the switch. Speed will vary from 0 to 100% of power supply voltage as the pot is rotated CW. Caution: You should always set the speed to zero prior to changing direction to avoid gear damage to your locomotive.
- Page 4 Any 3-wire power cord will work. Set the power input switch on the side of the power supply for 115 VAC U.S. Output voltage should be 24 VDC maximum for use with the G-Scale Graphics Trackside R/C or Track Throttle.