Table of Contents
Advertisement
Quick Links
Caution
•
Tie down long or wide loads at the front and rear of the vehicle with non-elastic straps. If it looks like it can catch
some air, it will. TIE IT DOWN!
•
When loading your surf gear or kayak, ensure that it is mounted correctly using the tie downs provided and is
positioned centrally, parallel to the vehicle.
•
Check straps periodically during travel and tighten if necessary. Replace any straps that are worn or frayed before
using (see your Prorack dealer).
Important Warning
•
It is critical that all Prorack racks and accessories be properly and securely attached to your vehicle. Improper
attachment could result in an automobile accident, and could cause serious bodily injury or death to you or to others.
•
You are responsible for securing the racks and accessories to your car, checking the attachments prior to use, and
periodically inspecting the products for adjustment, wear, and damage. Therefore, you must read and understand all
of the instructions and cautions supplied with your Prorack product prior to installation or use.
•
If you do not understand all of the instructions and cautions, or if you have no mechanical experience and are not
thoroughly familiar with the installation procedures, you should have the product installed by a professional installer
such as a boat carrier specialist.
Kit Contents
Item
Component
1
Prorack Cradle RHS
2
Prorack Cradle LHS
3
Standard/Rectangular Bar Adaptor
4
HD Adapter
5
Tie Down Strap Assembly
6
T15 Torx Head Plastite Screw
7
M6 Button Head Cap Screw
8
T15 Torx Screwdriver
9
Allen Key
10
"S" Hook
11
Black Nylon Rope
1
8
PR3032NK
0900354 PR3032 - Rev7
Kayak Carrier with Pivot Cradles
Qty
2
2
4
4
2
16
4
1
1
2
2
2
9
This product is designed to work
with Prorack Aero, Standard,
Trade and other Round Bars.
Max Load 70 kg
3
6
5
10
Minimum Crossbar
Spread 61 cm
4
7
11
Page 1 of 8
Advertisement
Table of Contents
Summary of Contents for Prorack PR3032NK
- Page 1 Important Warning • It is critical that all Prorack racks and accessories be properly and securely attached to your vehicle. Improper attachment could result in an automobile accident, and could cause serious bodily injury or death to you or to others.
- Page 2 NOTE! Kayak cradle knob has to be fully backed off (anti-clockwise) for the adapter to slide into the cradle or the cradle to slide in to a T-slot • The top of the wedges should be level with surround, as shown. •...
- Page 3 Slide kayak cradle into T-slot crossbar Position where you want the accessory to be. Installation on Prorack Standard Bar and other rectangular crossbars For this crossbar type, ensure you have Open rectangular bar adapter flap...
- Page 4 Position where you want the Repeat for all accessory to be. items. Installation on Prorack Heavy Duty For this crossbar type, ensure you have Use the Hex Key to remove the correct adapter as shown endcap screw...
- Page 5 Remove the endcap by pulling on the Slide adapter onto base of kayak cradle endcap pin and pushing on the top of the endcap Use a side to side motion to assist. Fasten adapter to kayak cradle with Slide kayak cradle into crossbar provided torx screws and torx key NOTE: With some crossbars, the roof rack...
- Page 6 Roll kayak forward Outside cradles will turn with Kayak, to position onto both cradles. Cradles should fit hull closely to prevent movement during transport Make sure there is a gap between kayak hull and the crossbar. Tighten the black plastic knob. Do not over tighten. Adjust boat position as necessary Thread free end of strap Use straps to secure boat to roof rack bars...
- Page 7 Tie one end of each rope to each hook Attach the other hook to rear of vehicle Attach one hook to front of vehicle Secure front and rear of kayak to vehicle Attach ropes to grab handle or rescue bar and pull tight. Securely tie off ends to create even pressure between front and rear.
- Page 8 Attachment hardware can loosen over time: - Check straps periodically during travel and tighten if necessary. - Replace any straps that are worn or frayed before using (see your Prorack dealer). • Some longer loads may prevent the rear hatch from fully opening.
Need help?
Do you have a question about the PR3032NK and is the answer not in the manual?
Questions and answers